Recommended Baseplate and Adapter to Tow a 2010 Jeep Wrangler w/ a Blue Ox Tow Bar

Question:

2010 Jeep Wrangler with Blue ox Bx7335 tow bar. I Will use adapter 98986 with a 98949 base plate. Will part 8stud of base plate,mate with part 4 on the Tabless adapter 98986. Does it need a clevis to connect?

asked by: Steve

Expert Reply:

Yes, it will! The Blue Ox Tow Bar Adapter Brackets item # e98986 will allow you to connect your Blue Ox Aventa II BX7335 tow bar to the etrailer Invisible Base Plate Kit item # e98949 that is confirmed to fit a 2010 Jeep Wrangler. No, you will not need a a clevis.

The etrailer Invisible Base Plate Kit item # e98949 fits the 2010 Wranglers with the factory bumper. I have linked an installation video below to help you get it set up.

Here are the rest of the parts you will need to flat tow your Jeep:

Wiring Harness - Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit item # RM-15267

Supplemental Braking System - Blue Ox Patriot Portable Flat Tow Brake System item # BLU37TR

Battery Disconnect - Roadmaster Battery Disconnect with Switch for Towed Vehicle w/ Flat Tow Brake System item # RM-766

High Low Adapter - The tow bar needs to be within 3" of level. If you measure the height of the inside top of the hitch receiver tube on your RV, and the height difference is more than 3 inches above/below the base plate tab height, you'll need a high/low adapter. I have linked a FAQ article that explains all this in more detail along with our selection of adapters.