Replacement Bearing And Seals For UFP Hub H-1062-2

Question:

Do you sell a Bearing/Seal kit for a UFP Hub H-1062-2? I have seal savers installed on the spindles. I also need dust covers for the same hubs - 1.9700 in. Thanks

asked by: Greg S

Expert Reply:

Hey Greg,

There unfortunately there isn't a guide to tell us the bearing and grease seal combination for your hub so you'll have to remove it and check the bearings/seal for their part numbers or use a digital caliper # PTW80157 to measure the spindle at points B, C, and D from the diagram below.

We unfortunately do not have a grease seal with a 1.9700" diameter.

expert reply by: Kevin C

Spindle Measurement Guide
(click to enlarge)

Greg

4/2/2024

Seal - 1.38 with seal saver installed Inner Bearing - 1.143 Outer Bearing - 1.065

Kevin C.

4/4/2024

@Greg Unfortunately it looks like we do not have the correct bearings for your spindle. At this point the only option we can offer would be replacement of the axle to get a more common spindle. If you can't find the correct replacement somewhere else and decide to bite the bullet on a new axle then give our customer service department a call at (800) 298-8924 and we can help walk you through the ordering process.

Greg

4/4/2024

@KevinC Thanks so much for your help. I was able to reuse my bearings and seal as they were in really good condition. The trailer does not get a lot of use. I will run it for a while and keep an eye on it. One day I will have to just get a new axle. Thanks again.