Can Gen-Y Weld On 2 inch Receiver Weld to 11 Gauge Square Tubing
Question:
Code: 325-GH-003 Can I weld this part directly to 2inch 11ga square tubing? Im building a small trailer and want to have the ability to remove the lok n roll coupler from the trailer.
asked by: James K
0
Expert Reply:
Hey James, yes you could weld the Gen-Y Weld-On 2" Receiver Tube # 325-GH-003 to 11 gauge square tubing like you asked about.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Gen-Y Weld-On 2" Receiver Tube - 12" Long - Steel
- Hitch Fabrication Parts
- Receiver Tube
- 12 Inch Long
- Raw Finish
- Fits 2 Inch Hitch
- Gen-Y Hitch
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Article: Most Popular Wheel Bearings
- Article: The Differences Between Cam Buckles and Ratchet Straps (And Who Would Win In a Fight)
- Article: Trailer Hitch Receiver Sizes
- Q&A: Recommended Hitch for a 2022 Volvo XC60 Recharge
- Article: Best Bike Racks for Electric Bikes
- Article: Best Bike Racks for Fat Bikes
- Q&A: Height of TorkLift StableLoad Suspension Upgrade for Upper Overload Springs # TLA7200
- Q&A: Outer Tube Dimensions Of The Buyers Products Receiver Tube # 337RT25818B
- Q&A: Wall Thickness and Outer Diameter of Buyers Products Plain Receiver Tube 337RT255812
- Q&A: Recommended Replacement Parts for 2 Inch Square Trailer Tongue
- Q&A: Replacement Landing Gear Spring Loaded Pull Pins For Lippert 2-1/4" Landing Gear With 3/8" Pin
- Q&A: Mounting Pipe Diameter For The Ark Removable Xtreme Off-Road Swing-Up Trailer Jack
- Article: Trailer Wiring Diagrams