Replacement Landing Gear Lead Leg for 2015 Sprinter 5th Wheel
Question:
I have a 2015 Spinter 5th wheel and the power drive on the landing gear leg is bad. I’m wanting to replace that leg but don’t know the right part to buy. It’s 291/2 tall and 2 1/2 inches wide. The drive shaft is a 1/2 shaft from the leg.
asked by: Joe B
Expert Reply:
Based on your dimensions the Replacement Lead Jack w/ Drop Leg for Stromberg Carlson Landing Gear # LG-179013 you looked at will likely fit. This works as a replacement for a lot of different landing gear sets like Atwood, Venture, and Lippert.
It is 29-1/2" tall x 2-1/2" wide with a 1/2" drive shaft. The leg has a total lift of 34-7/8" with 19-7/8" of travel. I would double check the distance between your weld stops to see if those match up as well. As long as your inside to inside measurement is 15-1/2" and your outside to outside is 17-1/2" this will work for you.
Product Page this Question was Asked From
Replacement Lead Jack w/ Drop Leg for Stromberg Carlson Landing Gear - 29-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Replacment Landing Gear Leg for Atwood Landing Gear
- Q&A: Replacement Leg for Lippert Ground Control 2.0 LC241846
- Q&A: Are Replacement Parts for Atwood Landing Gear Available or Will Another Brand Fit
- Article: Trailer Tire Sizing
- Q&A: Replacement Slide Out Motor For Lippert RV-8000-1 On a Glufstream Kingsport 301TB
- Q&A: How to Measure to Pick Out Replacement Landing Gear for a Trailer
- Q&A: Replacement Landing Gear Legs for a 2010 Jayco Eagle Super Lite
- Q&A: How to Pick Out Landing Gear for 2010 Jayco Eagle
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Types of Bumpers
- Article: Stability Control for Heavy Duty Vehicles