Is Correct Track Trailer Alignment and Lift Kit Compatible With MORryde Suspension Upgrade Kit

Question:

Are the moryde style wet bolts long enough to use with the correct track lift kit?

asked by: Kevin

Expert Reply:

If you install the Correct Track Trailer Alignment and Lift Kit # RR23QX it will require longer bolts but MORryde makes a kit specifically for this. To find the right MORryde Suspension Upgrade Kit for Tandem Axle Trailers w Correct Track you will need the center to center bolt hole measurement from your current shackle straps.

If you have 2-1/4" shackles you need the MORryde Suspension Upgrade Kit for Tandem Axle Trailers w Correct Track # MR58ZR. If you have 3-1/8" you need the # MR98ZR instead. You will also need two additional # MR52HR. The kit was originally made for a different version of the Correct Track and MORryde hasn't updated it yet. The two 2-7/8" long bolts need to be replaced with these 3-3/8" long bolts. If you already have the regular kit you can just swap out your 2-7/8" bolts for the # MR52HR.

expert reply by: Robin H

Kevin

3/20/2024

How safe is the correct track trailer alignment and lift kit #RR23QX? It seems like it would put excessive stress on the welds on the spring mounting brackets/hangers, especially under periods of hard braking or under side loads during sharp turns at driving speed.

Robin H.

3/28/2024

@Kevin it is completely safe to use this kit. There won't be any excessive stress applied to the hangers that would cause the weld to break. You're basically extending them without completely replacing them. You could add new hangers that are longer to achieve the same lift and the weld would be the same.

Kevin

3/28/2024

@RobinH sounds good, thanks for the info!