Will The Replacement Bridge Assembly DL92QR Work With A Dayton Winch?

Question

Question:

Will this bridge work for a Dayton 5W474 winch?

asked by: Bill E

0

Expert Reply:

We may be able to help you narrow it down. I was not able to find any kind of build sheet that would tell me exactly what bridge is used in the Dayton 5W474 winch that you mentioned. It is really not possible to say with certainty if it will work or not. What I can tell you is that the Replacement Bridge Assembly # DL92QR is a direct replacement of part CP2506. This number should appear printed on the side of the bridge itself.

Our records indicate that this bridge will work with the following Dutton-Lainson StrongArm AC-powered electric winches: SA5000AC, SA5000AC-CSA, SA5015AC, SA50151AC-CSA, SA7000AC, SA7000AC-CSA, SA7017AC, and SA7015AC-CSA.

expert reply by: Jesse M

0

Replacement Bridge Assembly Part Number
(click to enlarge)

Answer 1

I have the part you need! I went ahead and reached out to my contact at Dutton-Lainson, and they confirmed that the replacement rectifier you need is the Replacement Bridge Assembly for AC Powered Dutton-Lainson StrongArm Electric Winch - Qty 1…

view full answer...

Answer 2

Hey Joshua. Yes, the bridge/rectifier could definitely cause a tripped breaker if something has gone bad. if you are seeing burned areas this is definitely not a good sign and is likely an indicator that the bridge assembly needs to be replaced.…

view full answer...

Answer 3

I wouldn't submerge the Dutton-Lainson Remote Hand-Held Switch for AC StrongArm Electric Winches #DL24052 but it would handle some exposure to weather and water. When not in use I would recommend storing it out of the direct path of rain…

view full answer...

Answer 4

Yes, to replace the motor on your Dutton-Lainson powered winch you just need the part #DL304921. This the exact 90-946 100VDC 7.7 max amp motor you are needing.

view full answer...

Answer 5

If your Dutton-Lainson StrongArm Electric Winch #DL25019 is blowing the fuse when you are pulling the line in there are a few things to check. First of all look at the motor wire and check for any places where the insulation is damaged, especially…

view full answer...

Answer 6

I am assuming the boat is on a trailer when stored in the boat house which will make things a lot easier. So basically what you could do is use a winch that can pull/lower the trailer and boat up and down the ramp. To load the boat on the trailer you…

view full answer...

Answer 7

I spoke with my contact at Dutton Lainson and she stated that the StrongArm Electric Davit Winch, #DL25032, would work well for the 800 pound vertical lift as the winch does not have a clutch. I have included a link to the installation details for…

view full answer...

Will The Replacement Bridge Assembly DL92QR Work With A Dayton Winch?

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching