Does The Front of the Tuson Asymmetric Sway Control # 335TSC-1000 Have to Face The Front or Rear of
Question:
When mounting Tuson sway control, does it matter if front side of module is facing front of trailer or rear of trailer, since left and right might be switched if module is facing aft of trailer
asked by: Steve P
Expert Reply:
The Tuson Asymmetric Sway Control # 335TSC-1000 can be mounted with the front label side of the module facing the front or rear of the trailer. It is often preferred to install it so the unit with the label facing the rear as this will typically place it on the back of a crossmember and better protect it from road debris. The device has accelerometers so it can tell what direction of travel it is in so it will activate the correct side brakes.
Product Page this Question was Asked From
Tuson Asymmetric Sway Control - 1 to 4 Axles
- Weight Distribution Hitch
- Sway Control Only
- Severe Sway
- Tuson RV Brakes
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Comparing Tuson and Curt Electronic Sway Control Devices
- Q&A: Will the Curt True Course Advanced Bluetooth Trailer Sway Control Correct Minor Sway Events
- Q&A: Tuson Sway Control Location and Orientation
- Q&A: Mounting Orientation of Tuson Electronic Sway Control System
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Q&A: Tuson Electronic Sway Control Experiencing Tail Wag At Speeds Over 65 MPH On 2015 Toyota Tundra
- Q&A: Installation Location of Tuson Electronic Sway Control for Electric Trailer Brakes
- Q&A: Comparing the Tuson and Lippert Electric Trailer Sway Control Systems
- Article: Determining Trailer Tongue Weight
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Wiring Diagrams
- Article: Roadmaster Vehicle Specific Base Plates
- Article: How to Measure for Trailer Hitch Drop
- Article: Testing Trailer Brake Magnets for Proper Function