Availability of 90 Degree Elbow Fitting for RV Freshwater Line

Question

Question:

I have a 2003 Southwind, Workhorse chases. I need a 90 degree connector from the tube to the water pump. No fittings show up when I use your search window. Thank you,

asked by: Chuck H

0

Expert Reply:

Sounds like you are looking for the Flair-It PEX 90-Degree Elbow Fitting # FL36VR which is a 90 degree freshwater elbow fitting.

expert reply by: Jameson C

0

Answer 1

Yes, the BOLT Trailer Hitch Receiver Lock for 2" and 2-1/2" Hitches #BL7023585 that you referenced would be strong enough for towing a 10,000 lb travel trailer like you have. Hitch pins like this don't normally have stated…

view full answer...

Answer 2

Yes! The Empire Faucets RV Kitchen Faucet w/ Pull-Down Spout #EM42HR you were looking at fits perfectly. This particular faucet provides two mounting options, the same 3 hole design as the Ultra Faucets Model or a single hole option, using just the…

view full answer...

Answer 3

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory…

view full answer...

Answer 4

That is correct, you can tap into the plug and it will provide a charge but keep in mind that this is not the most efficient way for charging a battery. This method does not provide any charge balancing or battery charge management and on newer…

view full answer...

Answer 5

Yes. The M421KR is a Petersen part and the Optronics equivalent is the Sealed, 6-1/2 inch Oval Trailer Stop, Turn and Tail Light, 3-Function, #ST70RB, that you have referenced. For a complete set up, you will need Rubber Grommet #A70GB, and Straight…

view full answer...

Answer 6

The correct manual override cover for your 3,500lb electric Ram jack is the Replacement Manual Override Cap for etrailer A-Frame Electric Jack #EJ-3520-BCP. For a cover you can use the Ultra-Fab Protective Cover for Electric A-Frame Jacks…

view full answer...

Answer 7

The Floë Integrated Drain Down System #LC88FR is going to be installed in the line that runs between the the fresh water tank and filter/water pump. Basically this means before the water pump and filter, which will keep the water and air…

view full answer...

Answer 8

To replace the controller for the Replacement Vacuum Generator for Dometic VacuFlush RV Toilet #DOM46FR you need the Replacement Touchpad for Dometic VacuFlush and MasterFlush RV Toilets #DOM36FR.

view full answer...

Answer 9

I agree, that note doesn't make sense. When I reached out to my contact at MORryde they said the MORryde RV Generator Slide Out Tray #MR79RR doesn't have a stopper for when the tray is in the fully opened position so you just need to make…

view full answer...

Availability of 90 Degree Elbow Fitting for RV Freshwater Line

Product Page this Question was Asked From

Continue Researching