Recommended Hub Covers for a 5 on 5 and 5 on 4 1/2 Bolt Pattern

Question

Question:

Do you offer these hub caps in black?

asked by: Denise

0

Expert Reply:

Unfortunately no, the Phoenix USA QuickTrim Hub Cover for Trailer Wheels # PXQT550CH4 is only available in chrome. We do have the Phoenix USA QuickTrim Hub Cover for Trailer Wheels # PXQT545BHS which is identical but it only works with a 5 on 4 1/2 bolt pattern.

expert reply by: Bryce D

0

Answer 1

The Prime Guard Wheel Bearing Hi-Temp Red Grease part #L11380 16-oz tub will be enough to pack the wheel bearings and grease the spindle on your travel trailer. I have attached a helpful article for your reference about packing the bearings. The…

view full answer...

Answer 2

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs and…

view full answer...

Answer 3

The proper mounting location for side marker lights such as #MC32AB are as follows: For rear side marker lights you must have one on each side of your trailer and as far toward the rear of trailer as possible. They will need to be 15 inches or more…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

I am sorry I don't have any tires that are going to fit your rim. I do have a couple of comparable size tires that come in a wheel tire combo. I have listed the two below along with their lug patterns. 5 on 4-1/2 Lug Pattern - Kenda 205/65-10…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Recommended Hub Covers for a 5 on 5 and 5 on 4 1/2 Bolt Pattern

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching