Ramp Spring Lift Assist for Flat Bed Trailer without Side Rails
Question:
I need a trailer gate lift assist that is made for a flatbed trailer or car hauler without side rails. Do you have one that will work? The gate is 77” wide x 51” long and it mounts on the bottom of a 2’ dovetail. Thanks
asked by: James G
0
Expert Reply:
Since you don't have any rails on your flat bed trailer you would need to go with a ramp spring like the part # RS16933LH and # RS16933RH as long as your ramps are attached to a 1-1/2 inch shaft.
expert reply by:
Jameson C
0
Products Referenced in This Question
Ramp Spring - 2K Torque for 1-1/2" Shaft - RH
- Trailer Ramp Springs
- Single Ramp Spring
- Right Hand Spring
- 10 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Product Page this Question was Asked From
Ramp Spring - 2K Torque for 1-1/2" Round Shaft - LH
- Trailer Ramp Springs
- Single Ramp Spring
- Left Hand Spring
- 11 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Continue Researching
- Shop: Ramp Spring - 2K Torque for 1-1/2" Shaft - RH
- Q&A: Seal With Dimensions to Replace 171255UC
- Q&A: Solution for Squeaky/Noisy Trailer Suspension with Equa-Flex Equalizers
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Wiring Diagram for Bargman 7-Way RV Style Connector # WG54006-043
- Q&A: Recommended Load Resistor Adapter for Furrion Observation Camera on Travel Trailer for Signal
- Q&A: 7-Way Furrion Power Adapter Fix For 2021-2022 Chevrolet/GM Trucks
- Q&A: Damaged Caused to Travel Trailer Brake Drums and Bearings by High Temperatures
- Article: Trailer Wiring Diagrams
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Calculating Portable Generator Power Needs
- Article: Trailer Tire Sizing
- Article: RV and Camper Types, RV Classes
- Article: Double-Eye Trailer Suspension System Review