bing tracking image
Summer Starts Here - Save up to 70%
SAVE NOW
Customer Service My Orders
Q & A Icon

Where is Stoplight Circuit Switch on 2011 Subaru Legacy for Brake Controller Install  

Question:

Where is the break signal wire on a 2011 subaru legacy? I see the break light switch and the petal, petal is hydraulic and I see on wires attached in cabin. Is it converting that hydraulic into a digital signal somewhere else and is a wire there I can tap into?

0

Expert Reply:

Use a circuit tester like the part # PTW2993 to test the wires that run to the brake light switch you have found till you find one that has voltage only when the brake pedal is pushed. This is the correct circuit to tap into for the red wire of your brake controller install.

expert reply by:
0
Jameson C
Ask The Experts a Question >>

Products Referenced in This Question


Product Page this Question was Asked From


Featured Help Information

Instructions

Instructions for TK90160
Q & A Icon

Continue Researching

See More Q&A Expert Answers >>