Troubleshooting No Signal With A Furrion Vision S RV Camera System

Question:

I have a vision s 7 rear camera. Im getting power to the camera but no signal. If I hook it directly to the monitor it works

asked by: Ralph T

Expert Reply:

If your Furrion Vision S Camera System # FOS43TASF is getting power and still not connecting then it most likely isn't receiving enough power. The camera system requires a constant 12 volts to operate and depending on the vehicle you're towing the trailer with you could potentially have PWM wiring. PWM wiring provides a flickering power source which will allow the camera to turn on but not fully function.

The solution is to splice the PWM Filter # VGR64VR into the wiring behind the camera. This filter will store power and provide a constant 12 volt power source for the camera to properly operate. I've attached a video below where I'll walk you through the installation process.

expert reply by: Kevin C