Reliable RV Roof Vent with Fan Similar to MaxxFan

Question

Question:

I like the design of the unit - the large fan is in a cowling that will direct almost all of the air upward rather than letting a lot of the air just move around. But the reviews make me conclude that the controller board is unreliable. Are there any other fans like this with a relatively simple electric switch to the speeds rather than a circuit board that is subject to failure? Or at least any that could be re-wired, depending on whether the unit has one wire and is controlled by changing the voltage or has multiple wires that could be controlled by a multi-position switch?

asked by: George H

0

Expert Reply:

The MaxxFans and the Fan-Tastic roof vents like the # FV802250 both have the cowling around the fan to pull the air up more directly compared to the Ventline that has the smaller fan on the bigger screen. Since the Fan-Tastic roof vents seem to have a better reputation that would be what I would recommend.

expert reply by: Jameson C

0

Answer 1

There are and were numerous 2-step Kwikee electric steps available. To ensure we get you the correct replacement I would need to know the series of the steps you have. Check the underside of your steps for any model numbers or other information. The…

view full answer...

Answer 2

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 3

Yes most of the T@G campers I have seen use the Yakima 54" Tracks for Roof Racks part #Y01127 base tracks. You can get evrything you need in one kit with the Yakima HardTop SL Roof Rack - 60" CoreBar Crossbars - 54" Tracks part #Y01618…

view full answer...

Answer 4

To drop the front of the pin box and thus lower the front of the fifth wheel, you'd need to RAISE the pin box, not lower it. Lowering the pin box would raise the height of the fifth wheel at the front. If you have an available set of holes at the…

view full answer...

Answer 5

I can definitely help you find the correct replacement hub and bearings for your Dexter P-12 SLR axle, but since part of the serial number was unreadable you will need to take a few simple steps to identify which bearings your axle uses. The easiest…

view full answer...

Answer 6

There isn't going to be any noticeable difference in the fit between the Draw-Tite Trailer Hitch #75549 and Curt Trailer Hitch #C13388 that fit your 2019 Mercedes-Benz Sprinter 2500 with a 170 inch wheelbase and standard bumper. The reason for…

view full answer...

Answer 7

The Dexter E-Z Flex Suspension Kit part #K71-653-00 will work just fine on 3,500 axles assuming the measurements match up which in your case they do. I have spoken to Dexter about this before and the weight capacity listed is more or less a guide to…

view full answer...

Answer 8

If you have more of the weight in the trailer on the left side then that could explain the uneven wear. Axles have a bow or camber in the middle. When weight is in the trailer it straightens out the axle some and the tires should wear evenly. When…

view full answer...

Reliable RV Roof Vent with Fan Similar to MaxxFan

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching