Recommended Air Bag Kit For A 1999 Chevy 3500 Dually

Question

Question:

I have a 1999 chevy 3500 dually. What rear air spring is recommended. Is it possible to not drill holes?

asked by: Matt S

0

Expert Reply:

I can certainly point you in the right direction. For your 1999 Chevy 3500 Dually I recommend the Air lift Loadlifter 5000 ultimate # AL88216. For the 1999 3500 dually your options are limited, and this will be the best available for your truck. The 5000 Ultimate kit comes with stainless air lines. The bags also feature internal jounce bumpers. These add stability, and also act as a failsafe if you ever were to loose pressure.

Unfortunately we do not offer a no-drill option, and you will have to put holes in the frame during installation. This kit also is not compatible with an in bed fifth wheel or gooseneck hitch, as the brackets mount in the same location as the hitch brackets.

I have linked our review video, as well as installation instructions below if you want to take a look.

expert reply by: Jesse M

0

Answer 1

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey David, actually what is going to make the biggest improvement in handling and stability for your 2011 Itasca is an upgraded rear sway bar with the part #RM-1139-175. I know that's not what you asked about but for motorhomes where most of the…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Yes we do have a set of Timbrens that fit your 2024 Toyota Tundra with the part #T45MR. These can give you up to an additional 6,000 lbs of suspension support.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The correct Roadactive kit that fits your 2023 Ford F-150 is the part #RAS3611-YHD. I really like the RAS kits as they basically don't have any downsides. You get the adjustable support, an easy install, no maintenance, and actually improves…

view full answer...

Answer 9

Roadmasters priority when it comes to their sway bars is top notch quality and the easiest install for the customer. This typically cuts the install time down enough that you end up saving money if you pay to have the bars installed or decide to do…

view full answer...