Inner Tube Dimensions Of The etrailer Stabilizer Jack # TJ01RT
Question:
Hello- Looking for the internal measurements that slides inside the housing of the foot portion of the jack TJ01RT. I have a 1998 Jayco Eagle 12UDK and one of the internal feet fell off. They are welded on and I think this jack foot might fit, but need the internal measurements to be sure. If not, ill have to have the entire assembly cut out and purchase a new one and have it welded on. Appreciate it!
asked by: Rob O
0
Expert Reply:
The internal tube (drop leg) of the etrailer Stabilizer Jack # TJ01RT is 1-7/16" x 1-1/2".
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Stabilizer Jack - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 1
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 0 - 1000 lbs
- Drop Down Jack
- Bolt-On
- Weld-On
- 1 Jack
- etrailer
more information >
Continue Researching
- Q&A: Installation Information for the Replacement Cables for Enclosed Trailer Ramp Spring # ERS160D96
- Article: Most Popular Wheel Bearings
- Article: How to Measure for Trailer Hitch Drop
- Q&A: How Does the Domar Stabilizer Jack Operate
- Q&A: Correct Replacement Parts for a Ventline VD0434 Roof Vent
- Q&A: Recommended Tow Bar Wiring Kit For Flat Towing A 2024 Jeep Wrangler With ParkSense
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Article: Trailer Wiring Diagrams
- Q&A: Is Roadmaster Universal Hy-Power Diode Kit the Correct Flat Tow Wiring for a 2024 Jeep Wrangler
- Q&A: Can I Upgrade My 3,500 lb Leaf Springs To 5,000 lb Springs If The Measurements Match?
- Article: Where to Position the Trailer Axle?
- Article: Don't Break Your Pipes or Your Wallet: Winterize and De-Winterize Your RV
- Article: Determining Trailer Tongue Weight
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)