Correct Torklift Rear Camper Tie Down for 2020 GMC Sierra 1500 with Running Boards Dual Exhaust

Question

Question:

Hey guys Ive got a 2020 gmc sierra 1500. Im lookin to get a cabover camper. I have dual exhaust and steps. It looks like I would need TL54FR for the rear. Is that correct?

asked by: Nick M

0

Expert Reply:

Yes, I checked with Torklift and the correct rear camper tie down for your 2020 GMC Sierra 1500 dual exhaust with running boards is the part # TL54FR.

expert reply by: Jameson C

0

Answer 1

The correct front tie-downs for your 2021 GMC Sierra 1500 are the TorkLift Custom Frame-Mounted Camper Tie-Downs #TLC2224. The correct rear tie-downs depends on if your have dual exhaust or single exhaust. I have listed each option below.…

view full answer...

Answer 2

The TorkLift Basic SpringLoad Turnbuckles #TLS9000 actually have an adjustable length of 9 to 13 inches. Just the spring-loaded barrels measure about 4 inches. The two included chains are 24 inches long and 1/4 inch wide. I spoke with my contact at…

view full answer...

Answer 3

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

I'm assuming your 2024 F-250 has the 6-3/4' bed. If that is correct, the right tie-downs are in fact the #TLF3008 and #TL77CR. TorkLift has accounted for the bed access steps on the 2024 model and confirmed these will fit your truck.

view full answer...

Answer 9

Yes you can absolutely use the HappiJac Qwik-Load Turnbuckles for Camper Tie-Downs #LC182895 with your TorkLift tie downs.

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 12

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Correct Torklift Rear Camper Tie Down for 2020 GMC Sierra 1500 with Running Boards Dual Exhaust

Product Page this Question was Asked From

Continue Researching