Recommended Rear Awning for Ram ProMaster 2500

Question

Question:

Do you guys sell a rear awning or know somewhere that may for the Ram Promaster 2500?

asked by: Chad J

0

Expert Reply:

I do have options for you for a rear awning but these are rather niche, most as you have come to find out I'm sure are for the side. The only options we have for the rear are universal, the Kelty Sideroads Car Awning part # KE38KR or Kelty Backroads Car Awning with Side Walls part # KE98KR.

expert reply by: Conner L

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 4

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 5

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 6

I have a couple options for your Carolyn. The first is to replace your current side rails with the XR Rails #RTT-82381 on the Cover #RTX37VR so you will have the T-Slots. Other wise using a reack like the Adarac #A54KG would be an option as this…

view full answer...

Answer 7

I checked the reviews on the Curt Trailer Hitch Receiver #C13397 product page and we have had a number of customers install the hitch on the 2023 and 2024 CR-V Hybrid (including the Sport), and it does fit. We also installed the #C13397 on a hybrid…

view full answer...

Answer 8

Typically when a monitor gets horizontal lines across it like you are describing it is one of two things. Either the connection cable is bad or the monitor is damaged/failing. Since this is a wireless system without a cable, I would say it is the…

view full answer...

Answer 9

I have attached for you below an excerpt from the manual on the Curt TriFlex Trailer Brake Controller part #C24VV which goes over the brightness settings. Please let me know if you have any other questions. "Slowly tilt the front of the TriFlex…

view full answer...

Answer 10

The first thing you should do is check is to make sure you have the wiring correct and not reversed. The white wire should be grounded and black to 12 volt power. If the wiring is correct make sure it's getting 12VDC power and the connections are…

view full answer...

Answer 11

The Rhino-Rack Dome 1300 Awning, #RR32125 is designed as a bolt-on mount that uses top channels in certain models of roof racks for attaching the L-brackets. See attached image. As is, the designed mounting hardware supplied does not match this to…

view full answer...

Answer 12

The Yakima SlimShady Awning #Y96VR only has brackets for clamping onto a crossbar. The minimum size crossbar thickness needed would be 1" for these clamps. You could most likely clamp these onto the crossbars you have on there but the plate they…

view full answer...

Recommended Rear Awning for Ram ProMaster 2500

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching