Troubleshooting An LR Error Code On A Lippert Ground Control 3.0 Leveling System
Question:
307296 ELECTRIC JACK 4pt 5TH WHEEL RF LEVELER. LR errors swapped right rear and left rear and still getting a LR error. What could be the issue.
asked by: Zachary
Expert Reply:
An LR error code would indicate an electrical error with the left rear jack. You'll want to start by checking the fuses on your controller to ensure that it hasn't blown. You can use a circuit tester # PTW2993 and touch it to both contacts on the top of the fuse to check for power. From there you would need to trace the wires back to the jack to see if there's any damage, loose connections, or corrosion.
If you find no damage then I would test the power at the jack using a multimeter # PT89ZR to see how much voltage is getting to it. If you're not getting 12.75 volts then your issue is the power source. If the power is fine then normally I would say the jack is bad and to swap it out with part # LC305339, but you stated you swapped the right over to test and still got the error so it really leads me to believe there's some sort of issue with the wiring running to the left leg or the controller is bad. Check out your wiring and let me know what you find and we can keep troubleshooting further if the issue isn't found.
Products Referenced in This Question
Replacement 24-1/2" Left Rear Leg - Lippert Ground Control 3.0 Electric Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Lippert
more information >
Digital Multimeter with 42" Long Test Leads - LED Display
- Electrical Tools
- Testers
- Multimeter
- Yellow
- Performance Tool
more information >
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Wiring Diagram and Fuse Location for the Lippert Ground Control 3.0 4-Point Leveling System
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: How to Raise Your Travel Trailer Height
- Q&A: Dimensions of Lippert Ground Control 3.0 Jacks For Clearance on Keystone Cougar 28SGS
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Double-Eye Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)