Kayak Carrier Recommendation for a 71 lb Perception Cove 14.5 ft Kayak

Question

Question:

Which of your flat carry rooftop racks would be best for a 71# Perception Cove 14.5 foot Kayak? Is the Sea Wing carrier sturdy enough for a 71# kayak? If the Mega Wing is preferred for the weight, will it properly support the Cove Hull? The hull is flatter in the mid region.

asked by: Eric B

0

Expert Reply:

The Malone SeaWing Kayak Roof Rack w/ Tie-Downs # MPG107MD has a weight capacity of 75 lbs so it will be able to handle your 71 lb kayak just fine, and is the kayak carrier that I recommend for your application. The MegaWing # MPG207 has the same basic profile as the SeaWing so it will fit the same with your kayak - the main difference is the MegaWing is more robust so it can handle up to a 150 lb kayak.

I do recommend picking up the Stinger Load Assist # MPG350 for the SeaWing as well since it will help make loading your heavier kayak much easier.

expert reply by: Jon G

0

Answer 1

So the big difference between the Malone MegaWing part #MPG207 and the SeaWing #MPG107MD is the weight capacity of either. The MegaWing is rated for up to 150 lbs and the SeaWing 75 lbs. You'd be fine with either as your Pelican Catch 100 has a…

view full answer...

Answer 2

Since your Perception Kayak-Rambler is a larger kayak I recommend using the Yakima Kayak Carrier with Tie-Downs #Y04083-04082. This combines the DeckHand and HandRoll carriers so that you get the ease of loading with the rollers but the stability…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 5

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 10

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...