Installation of the T-One Vehicle Wiring Harness, Part # 118411, on a 2007 Volvo XC90
Question:
INSTALLATION OF PART 118411
asked by: ADAMA
Expert Reply:
The T-One Vehicle Wiring Harness, item # 118411, is installed inside the vehicle access panel area at the rear of the vehicle. You will need to remove the cargo access door on the floor, the floor trim panels and the access panels on each side of the vehicle. The T-connectors will then be installed inline with the vehicle taillight wiring. You will need to install the ground wire to a suitable ground location and install the power wire to the vehicle power cable stud which is located on the drivers side below the fuse panel. I have posted complete instructions for you to review.
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Wiring Recommendation for a 2007 Volvo XC90
- Q&A: Replacement Hub and Drum Assemblies for AL/KO 8460 Hubs and Drums
- Q&A: Choosing Between Tekonsha or Curt Powered Taillight Converter/Wiring Harness for 2020 Honda Odyssey
- Q&A: How Much Should It Cost To Completely Rewire a Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What is Overlanding? How to Start your Overlanding Journey
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Will etrailer brand Cargo Carrier Part # e98874 Fit a 2005 Volvo XC90
- Q&A: Can I Tow a 17 Foot Boat with a 2002 Cadillac DeVille
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Maintenance Schedule