Recommended Scissor Stabilizer Jack For A 2012 Rockwood Mini Lite 1809S
Question:
Hello. We need to replace one of the stabilizer scissor jacks on our 2012 Rockwood Mini Lite 1809s. However, we do not know which one to buy as a replacement. We saw that stabilizers are based on weight but is that the weight of the whole trailer dry or packed with cargo and people? Thanks in advance for your help.
asked by: Teresa W
Expert Reply:
The stabilizer would only be receiving a small portion of the weight since the wheels and tongue jack would be holding the majority of the weight. They weight capacity is more so there just because if you use it to level the trailer it would be picking up more of the trailer's weight. We base everything off of the trailer's GVWR to be safe but most likely the trailer will weigh quite a bit less depending on how you packed it.
Your 2012 Rockwood Mini Lite 1809S travel trailer has a GVWR under 5,000lbs so adding four of the Scissor Stabilizer Jack # TJSC-24 to it would be more than enough capacity since the jacks are rated for 2,500lbs. If you like to order this stabilizer in a 4-pack you can use part # TJSCHD-24-4.
![Kevin C](https://images.etrailer.com/static/images/catg/people/2455_tn.jpg)
Products Referenced in This Question
Scissor Stabilizer Jacks w/ Handle - 18-3/4" Lift - 10,000 lbs - Qty 4
- Camper Jacks
- Fifth Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 9001 - 10000 lbs
- Scissor Jack
- 18-3/4 Inch Lift
- Bolt-On
- 4 Jacks
- etrailer
more information >
Product Page this Question was Asked From
Scissor Stabilizer Jack - 18-3/4" Travel - 2,500 lbs - Qty 1
- Camper Jacks
- Fifth Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 2001 - 3000 lbs
- Scissor Jack
- 18-3/4 Inch Lift
- Bolt-On
- 1 Jack
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Scissor Jack Options With A Low Retracted Height
- Q&A: Is New Mounting Hardware Needed For The etrailer Scissor Stabilizer Jack # TSJC-24
- Q&A: Which Install Harness For P2 Brake Controller for 2023 Nissan Frontier
- Q&A: Replacement Stabilizer Jacks for 2020 Rpod 195
- Q&A: Is the Handle of the TJSC-24 Scissor Jack Sold Separately
- Q&A: How Tight Should Spindle Castle Nuts be Tightened
- Q&A: Is Lippert Flow Max RV Toilet Good For Part-Time RVers
- Article: Trailer Tire Sizing
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide