Dimensions Of The Yakima MajorShady 270 Awning Fabric

Question

Question:

Why dont you give the depth and width measurements in your description so people would know if this will work for them?

asked by: Ron

0

Expert Reply:

Yakima was unable to tell me the dimensions on the fabric for the Yakima MajorShady 270 Awning - Roof Rack Mount - Bolt On # Y72AV so I had one pulled from the warehouse and measured it myself. I've drawn up a little diagram below that shows this.

expert reply by: Kevin C

0

Yakima MajorShady Dimensions
(click to enlarge)

Answer 1

Yes! The Yakima MajorShady 270 Awning #Y72AV can definitely fit the Yakima OverHaul HD ladder rack on your truck. This awning installs via crossbar T-Slots and the OverHaul HD crossbars have the same dimensions as standard crossbars for the T-Slots…

view full answer...

Answer 2

You are correct, it is the Yakima Landing Pad 1 part #Y00221 that is compatible with the Truxedo Elevate TS rails.

view full answer...

Answer 3

I spoke with Yakima and they informed me the dimensions of the Yakima MajorShady 270 Awning part #Y82AV while closed are approximately 90" long. The bolt spacing at the rear is 4-1/2" for the clamp to the awning and 3-1/2" on the bar.

view full answer...

Answer 4

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 5

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 6

Both the Rhino-Rack Vortex Aero and Thule WingBar roof rack systems have very nice features and would work well for your 2014 Hyundai Santa Fe. Both systems are designed to work on vehicles that have the flush mounted rail system. As far as the…

view full answer...

Answer 7

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 8

For your setup I recommend the TrackTowers for Yakima Crossbars and Platforms - Track Mount #Y52AV which includes everything you need to mount Yakima crossbars to your Retrax cover (unless you plan on using the Round or HD bars - then you'll need…

view full answer...

Answer 9

I have a Yakima crossbar setup that is compatible with the Retrax Pro XR Tonneau Cover on your 2021 Toyota Tacoma, however, the Yakima Bedrock is not compatible and the 60" crossbars would be too short anyways. I recommend going with the…

view full answer...

Answer 10

Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…

view full answer...

Dimensions Of The Yakima MajorShady 270 Awning Fabric

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching