Replacement Round Tail Light For Kit Car With Obsolete 3-7/8" Diameter Tail Lights
Question:
need replacement for a LS328 red plastic lens from my classic kit car3 7/8 diameter, screw holes 3 in but about 1/2 off center.
asked by: Gerald A
0
Expert Reply:
It would appear those lights and lenses are obsolete. We do have the Peterson Tail Light # 432000 which has a similar design to your lights. This light is 3-3/4" in diameter, 2-5/8" thick and the mounting studs are 2" on center. If this lens were to break you can still get a Replacement Lens # 420-15.
expert reply by:
Bud M
0
Products Referenced in This Question
Replacement Red Lens for Peterson 3-3/4" Round Stud Mount Tail Lights
- Accessories and Parts
- Trailer Lights
- Light Lenses
- 3-3/4 Inch Diameter
- Round
- Red
- Peterson
more information >
Product Page this Question was Asked From
Peterson Trailer Tail Light - 4 Function - Incandescent - Round - Red Lens - Driver Side
- Trailer Lights
- Tail Lights
- License Plate
- Stop/Turn/Tail
- Round
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 3-3/4 Inch Diameter
- Red
- Peterson
more information >
Continue Researching
- Article: Top Gifts for Dads in 2024
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Grease Seal for a 168255TC Rubber Coated Seal
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012
- Q&A: Can Single Wire Clearance Light Be installed To Replace 2-Wire Light On Travel Trailer
- Q&A: Solution for Replacing Dexter 8-222 Trailer Hubs and Bearings
- Q&A: Will the Replacement Red Lens # A42RB Replace Do Ray SS-105
- Q&A: Welding Latch Pin Installation for Securing Trailer Ramp
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: SuperSprings Custom Stabilizer and Sway Kit For a 2004 Chevrolet Silverado 2500HD
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: How to Determine Correct Replacement Ceramic Kodiak Brake Pads
- Article: Jump Starting Your Vehicle
- Article: Trailer Maintenance Schedule