Propane Fitting Size Of The Camco Olympian Wave 8 Catalytic Safety Heater

Question

Question:

On the Olympian 8 heater,is the end Gor the heater 3/8 or 1/4?

asked by: D R

0

Expert Reply:

The Camco Olympian Wave 8 Catalytic Safety Heater for Large RVs # CAM57351 has a 3/8" SAE flare fitting so you would need a hose with a 3/8" Female Flare fitting like part # CAM57721. This hose is 12' in length and comes with a regulator so you can hook right up to the propane tank.

expert reply by: Kevin C

0

Answer 1

For a typical travel trailer propane setup you will have 1 of 2 pigtails. The first will have the Type 1 connector (with the green cap) and the other has a 1/4" MPT fitting like what we find on the pigtail #100473-12. I believe this is what you…

view full answer...

Answer 2

The Camco Olympian Wave 8 Catalytic Safety Heater, #CAM57351, is adjustable from 4,200 to 8,000 BTUs. It appears their rating of using 1/3 lb per hour is operating at, while not maximum, a high setting. A gallon of propane contains 91,502 BTU. There…

view full answer...

Answer 3

If you will be permanently installing the Camco Olympian Wave 3 Catalytic Safety Heater part #CAM57331 then you would need to run a hose from the heater to the propane manifold. I cannot recommend you tap or splice into an existing line. The fitting…

view full answer...

Answer 4

The Camco Olympain Wave 3, part #CAM57331, has a fuel consumption of 1/8 lb per hour and boasts a 96% efficiency. Camco does not have a website showing the burn times of this heater, but I have linked to a couple of video reviews of this heater that…

view full answer...

Answer 5

I spoke with my contact at Camco and he informed me that the BTU rating of the Camco Low-Pressure LP Gas Regulator #CAM57721 is 75,000.

view full answer...

Answer 6

Catalytic heaters like the #CAM57331 Wave 3 do indeed put out moisture as a byproduct of the heating process, it's unavoidable with that type of heater. After doing some research, I've found that the best bet to keeping a large part of the…

view full answer...

Answer 7

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

view full answer...

Answer 8

Thank you so much for the info and the pictures! According to my research it looks like your Cummins Onan RV Generator uses a 3/8" NPT Female fitting so you'll need a hose like part #100040-144-MBS. I have attached a link to all of our hose…

view full answer...

Answer 9

Yes, you'd just need to reach out to a qualified welder and have them weld on spring seats like part #TRSS300 to the top side of the Trailer Axle Beam with Easy Grease Spindles #e45GR. It's super common to do for people who have an underslung…

view full answer...

Answer 10

We do have the parts you need in order to run your Coleman stove from your trailer's quick disconnect, but you will also need a t-fitting to go with the hose. The reason you mentioned the stove has its own regulator; but your trailer's quick…

view full answer...

Answer 11

To add a in-bed 7-way to your 2024 Chevy Silverado 2500 to make towing with a 5th wheel easier, I recommend adding the Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 7' Long item #C58FV. This harness puts a 4-way and 7-way…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Propane Fitting Size Of The Camco Olympian Wave 8 Catalytic Safety Heater

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching