How to Determine if Ultra-Fab Deluxe Electric Landing Gear Set Will Fit Trailer

Question

Question:

2020 Eclipse Attitude 2919Sag Will these Ultra Fab jacks work on the factory mounts?

asked by: Jon T

0

Expert Reply:

You'll have to do some quick measuring to determine if the Ultra-Fab Deluxe Electric Landing Gear Set # UF17-943010 will fit the stock mounts on your Eclipse Attitude as we have no way of knowing that outright.

If the measurement is 13.5 inches you can use your stock hangers and will use stop tab A & B, and if the measurement is 19.125 inches you can use your stock hangers and will use stop tab A & C.

expert reply by: Kyle S

0

Dimensions For Ultra-Fab Deluxe Landing Gear Set
(click to enlarge)

Instructions For Ultra-Fab Deluxe Electric Landing Gear
(click to enlarge)

Answer 1

Atwood was sold to Dometic a few years back and replacement parts for older landing gear are scarce. We do still have Stromberg Carlson Landing Gear repair kit for the follow jack that will fit, part #LG-146060. For a lead jack repair kit use…

view full answer...

Answer 2

The ST235/85-16 tires that we provide all have maximum psi ratings of 80, 95 or 110 dependent on the load rating. For example, the load-range G Provider Radial Trailer Tire, #TTWPRG235R16, has a maximum load rating of 4,080 lbs at 110 psi while the…

view full answer...

Answer 3

Tire manufacturers advise that trailer tires need to be filled to the max psi listed on the sidewall of the tire while cold. Your new tires should be inflated to the 110 psi when cold. That pressure will fluctuate as you use the tires and the…

view full answer...

Answer 4

If you have more of the weight in the trailer on the left side then that could explain the uneven wear. Axles have a bow or camber in the middle. When weight is in the trailer it straightens out the axle some and the tires should wear evenly. When…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

How to Determine if Ultra-Fab Deluxe Electric Landing Gear Set Will Fit Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching