Troubleshooting A Furrion Vision S RV Camera System Monitor That Goes Black When Using View All

Question:

Just bought a used RV that has Vision S rear and side marker cameras models FCR48TAR and FCR48TAL, from the sticker on the camera installed, but no monitor, so I purchased the Vision S 7inch monitor FR47FR from eTrailer. I have all 3 cameras paired to the monitor, and I can each camera individually all show good signal with no outs. But when I View All, the monitor shows the 3-camera display for less than a second with no actual camera picture, just black on the screen with the camera labels and goes back to ing one of the individual cameras. And after that, the unit is basically hung, I cannot change the camera ion until I power cycle the monitor. After reading some RV forums, I disconnected each of the side cameras one at a time to determine if one of these was causing the issue. What I found is that if either of the side cameras or both are connected, then I have the View Allinch issue I described above. Since both side marker cameras cause the same problem, this wouldnt seem to be a bad camera. Any suggestions?

asked by: Steve H

Expert Reply:

I spoke with Furrion and found that this is a known issue with the wiring on the side marker cameras # FCE48TASL. A lot of people have been installing the trigger wire in with the power wire instead of running it to the turn signal or just capping it off. I've attached an installation video I did below where I show the wires for the cameras at the 6:18 minute mark.

You'll want to remove the whole side marker camera from the trailer to get to the wiring and disconnect the trigger wire and cap it off with some electrical tape.

If this doesn't solve the issue then let me know and we can keep troubleshooting until we have the issue resolved.

expert reply by: Kevin C