License Plate Bracket Options with Mounting Holes Closest to 3" Apart
Question:
Looking for a 19 nitro boat trailer license plate mount. Top screws are 3 on center - so holes on mount need to be 3 apart. Do you have anything that will work?
asked by: Michele A
0
Expert Reply:
After looking through our license plate brackets, I did not see any that had a spacing of 3" between the mounting points. We have two options, one being a little larger and one a little smaller.
- Trailer License Plate Bracket # LP20SB (3-1/2" between mounting points)
- License Plate Light Bracket # BK31BB (2-1/16" between mounting points)
Most of the license plate brackets have a spacing of 2", these are the closest two options that we carry.
expert reply by:
Scott S
0
Products Referenced in This Question
Product Page this Question was Asked From
Trailer License Plate Bracket - Powder Coated Steel - Qty 1
- Accessories and Parts
- License Plates and Frames
- Mounting Hardware
- Brackets
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: How to Pick Out Bearing for 10,000 lb Dexter Axle
- Q&A: Can the Kuat Pivot 2 Swing Away Hitch Extender Be Used With Cargo Carrier and How Much Can It Hold
- Q&A: Will Kuat Pivoting Assembly part # PVD20B Allow Access to Rear Door of Mercedes Sprinter
- Q&A: What Are the DOT Requirements for License Plate Lights
- Q&A: Parts Needed to Add Brakes to 2023 Big Tex 35SV Single Axle Trailer
- Q&A: Replacement Air Conditioner for RV Duo Therm 57915.531
- Q&A: Will The Lippert High-Speed Power Stabilizer Jack Fit The Frame Of A 2023 Jayco Jay Flight 265RLSW
- Article: Trailer Lighting Requirements
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Dielectric Grease Review
- Article: How to Tie Down a Motorcycle
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Rust Prevention