Recommended Flat Towing Parts for a 2019 Jeep Cherokee Trailhawk
Question:
Hello, i need some help putting together a kit to tow my vehicle behind my motor home. I just need to make sure Im getting everything that is needed. My RV is a 2021 Jayco Melbourne 24L and the vehicle is a 2019 trailhawk jeep cherokee 4x4. Thank you!
asked by: Hugo H
Expert Reply:
I would be happy to help you put together all the parts you need to flat tow your 2019 Jeep Cherokee Trailhawk. I have listed the parts you will need below and linked any installation videos we may have along with the instructions for each part.
Tow Bar and Safety Chains - Roadmaster Falcon 2 Tow Bar item # RM-520 and item # RM-643
Base Plate Kit - Roadmaster Direct-Connect Base Plate Kit - Removable Arms item # RM-521451-5
Wiring Harness - Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit item # RM-15267
Supplemental Braking System - Brake Buddy Select 3 Portable Supplemental Braking System item # HM39524
High Low Adapter - The tow bar needs to be within 3" of level. If you measure the height of the inside top of the hitch receiver tube on your RV, and the height difference is more than 3 inches above/below the base plate tab height, you'll need a high/low adapter. I have linked a FAQ article that explains all this in more detail along with our selection of adapters.
Products Referenced in This Question
Brake Buddy Select 3 Portable Flat Tow Brake System - Proportional
- Tow Bar Braking Systems
- Brake Systems
- Proportional System
- Recurring Set-Up
- Portable System
- Air Brakes
- Air Over Hydraulic Brakes
- Hydraulic Brakes
- Brake Buddy
more information >
Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Diode Kit
- Universal
- Tail Light Mount
- Roadmaster
more information >
Roadmaster Falcon 2 Tow Bar - RV Mount - 2" Hitch - 6,000 lbs
- Tow Bar
- Hitch Mount Style
- Telescoping
- Steel
- 6000 lbs
- Fits Roadmaster Base Plates - Crossbar
- Fits Roadmaster Base Plates - Direct Connect
- Stores on RV
- Standard
- Roadmaster
more information >
Roadmaster Direct-Connect Base Plate Kit - Removable Arms
- Base Plates
- Removable Drawbars
- Twist Lock Attachment
- Roadmaster
more information >
RoadMaster 68" Single Hook, Coiled Safety Cables - 6,000 lbs
- Safety Cables
- Coiled Cables
- 68 Inch Long
- 6000 lbs GTW
- Snap Hooks
- Coated Cables
- Roadmaster
more information >
Product Page this Question was Asked From
Blue Ox Ascent Non-Binding Tow Bar - RV Mount - 2" Hitch - 7,500 lbs
- Tow Bar
- Hitch Mount Style
- Telescoping
- Aluminum
- 7500 lbs
- Stores on RV
- Non-Binding
- Blue Ox
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Q&A: Hanger Spacing Dimensions for Installing Double-Eye Leaf Springs on a Trailer
- Q&A: Adding Brakes to a Mobile Home Axle
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Q&A: How to Wire Two 6-Volt Batteries In Series to Double Output Voltage
- Q&A: Installing a Brake Controller and a 7-Way Trailer Connector on a 2005 Ford F-150 With Factory 4-Way
- Q&A: How To Determine Blue Ox Spring Bar Weight Capacity
- Article: What To Look For When Buying Ratchet Straps
- Article: Replacement Automotive Lighting
- Article: How to Choose a High-Low Adapter
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Must-Have Flat Towing Components
- Article: Trailer Wiring Diagrams