Can Brake Controller Output be Checked with Override Lever
Question:
can you check 7 pin for voltage at pin for trailer brake using the manual activation button while trailer is not hooked up
asked by: VICTOR M
0
Expert Reply:
Yes, if you slide the manual override lever of a brake controller you can then use a circuit tester like part # PTW2992 to test for voltage on the output pin which would be in the 5:00 position.
expert reply by:
Jameson C
0
Products Referenced in This Question
Product Page this Question was Asked From
Curt Spectrum Trailer Brake Controller - Dash Mounted Knob - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Dash-Mounted Knob
- Hidden
- Up to 4 Axles
- Indicator Lights
- Up to 360 Degrees
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Comparing the Curt Spectrum Brake Controller to Redarc Tow-Pro Elite
- Article: Trailer Wiring Diagrams
- Q&A: How Does Curt TriFlex NEXT Brake Controller Mount
- Q&A: 7-Way Trailer Wiring Harness for 2024 Hyundai Santa Cruz
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Plug and Play Adapter to Install a Brake Controller in a 2024 Ram 2500
- Q&A: Parts Needed To Install Curt Assure Trailer Brake Controller On a 2024 Chevy Silverado 2500
- Q&A: Which Wiring Harness Fits 2024 Hyundai Santa Cruz With Tow Package