Fit Kit for Installing Yakima Legs on Thule Tracks for 2022 Toyota Tacoma

Question

Question:

HI, I Have a 2022 Toyota Tacoma with Thule Tracks on the camper shell. I already own Yakama rails and podium feet. Is there a fit kit that I can use to make the Yakama podium feet fit the Thule tracks? Thanks!!

asked by: Tina

0

Expert Reply:

Thanks for reaching out!

If you have the SkyLine Towers for Yakima Crossbars # Y53TR then all you need is 2 sets of the Landing Pad 26 # Y75ZR and you're set. If you have a different leg kit then you need the SkyLine towers to accomplish this as the other Yakima legs are for different installation types.

expert reply by: Jon G

0

Answer 1

It looks like you have the Thule Aeroblade bar. The T-slot dimensions are 1/2 inch wide for the top of the opening and 3/4 inch wide at the bottom. The T-slot is 1/8" inch tall.

view full answer...

Answer 2

Yes, the Yakima Landing Pad 1 part #Y00221 does fit the Thule tracks like part #THTP54 that you referenced.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

It's very easy to install a trailer brake controller on a 2021 Honda Ridgeline. I recommend the Tekonsha Prodigy P3 Trailer Brake Controller part #90195 which comes with a harness that you could simply attach to the one that came with the…

view full answer...

Answer 6

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...

Answer 7

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 8

Yes, the TrackTowers for Yakima Crossbars and Platforms #Y52AV that you referenced do fit the Rhino-Rack RTC-Style Roof Rack Tracks #RTC18.

view full answer...

Answer 9

The Thule TracRac CapRac Ladder Rack for Camper Shell/Truck Cap #TH29200XT is not actually meant to be installed into top tracks. This crossbar system is actually meant to be installed in fixed points on your camper shell so it's not going to…

view full answer...

Answer 10

The Yakima SightLine Towers #Y64AR and RidgeLine Towers #Y00145 are very similar. The main differences is the SightLine is slightly shorter by 1/2" at 3" tall. Also the SKS Locks #Y07204 is hidden behind the outer cover on the SightLine…

view full answer...

Answer 11

There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the CoreBar has…

view full answer...

Answer 12

Hey Andrew, yeah the 220lb capacity your bars are referring to is the dynamic capacity - so while the vehicle is in motion. When stopped the weight capacity is going to be likely around triple that since the weight won't be moving and be directly…

view full answer...

Fit Kit for Installing Yakima Legs on Thule Tracks for 2022 Toyota Tacoma

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching