What Size Thread Tap to Clean Out Weld Nuts of 2003 Honda Odyssey for Curt Hitch
Question:
The weld nuts on my Honda are bad! What size tap should I use to chase the threads to clean them out? The wire brush is not the right tool for this job
asked by: Richard A
0
Expert Reply:
The bolts of the Curt hitch part # C12031 that install in factory weldnuts are M12 -1.25x35 mm so the correct tap would be M12x1.25. The other size bolts that come with this hitch install with included nuts.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Will the etrailer Trailer Hitch e98840 for 2017 Acura MDX Work for Boat Towing
- Q&A: Best Bike Rack For Transporting A Step-Thru Ebike On The Back Of A 2015 Toyota Prius
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Recommended Trailer Hitch for 2017 Nissan Rogue
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Difference Between Curt and etrailer Hitches for a 2022 Subaru Crosstrek
- Q&A: Comparing The etrailer And Curt Trailer Hitches For A 2023 Toyota Sienna
- Article: My Trailer Hitch Doesn't Fit
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Q&A: Trailer Hitch And Wiring For A 2022 Honda CR-V Touring Hybrid With Hands Free Liftgate
- Article: Frequently Asked Questions About Transmission Coolers