Correct Replacement for Grand Design Electric Jack Motor 160084

Question

Question:

Do you have this motor, its # 160084?

asked by: Joe B

0

Expert Reply:

The Electric Jack Motor 160084 is a Grand Design part number which cross-references to the Replacement Hall Effect Motor for Lippert Components Ground Control 3.0 Leveling System part # LC343758.

expert reply by: Conner L

0

Correct Replacement for Grand Design Electric Jack Motor 160084
(click to enlarge)

Answer 1

Yes, for just a replacement motor for the Lippert Ground Control 3.0 part #LC358590 you would need the part #LC343758. I confirmed with my contact at Lippert this will replace the motor on your left rear leg.

view full answer...

Answer 2

For the front legs of a Lippert Ground Control 3.0 kit the replacement front jack leg solution you'd need is the part #LC362485. This will allow you to reuse your current motor and bracket. There isn't a gear replacement kit for the…

view full answer...

Answer 3

For the Lippert Ground Control 3.0 Trailer Leveling System #LC358590 we do offer the front leg only with part #LC362485.

view full answer...

Answer 4

Sounds like you have a Lippert Ground Control auto leveling system on your 2016 Highland Ridge Open Range like the #LC358590. For a replacement front leg you'd just need #LC362485 and you'd be set. The price for this is at the…

view full answer...

Answer 5

In regards to the Lippert Ground Ground Control 3.0 Leveling System, if you just need a new front leg then this can be replaced with the Replacement Front Jack for Lippert Components Ground Control 3.0 Leveling System part #LC362485. If you need a…

view full answer...

Answer 6

Do you get any error code on the controller for the Lippert Ground Control 3.0 #LC675817? Usually that helps to troubleshoot and the manual gives an exact solution for each error code. You might also try resetting the Zero Point Calibration to see if…

view full answer...

Answer 7

I did a little digging on your 2021 Grand Design Reflection 303RLS, and it appears you have the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote #LC358590. With that being said, you'll want to use the…

view full answer...

Answer 8

It sounds like you have the Lippert Ground Control Auto Leveling Landing Gear 3.0 part #LC358590 and are looking for replacement front landing gear legs. For that you would want the part #LC305340 . The part number for the rear would be #LC344792 for…

view full answer...

Answer 9

The distance between the insides of the weld stops on the jack leg #LC362485 is 17-1/2 inches and the outer tube diameter is 2-1/2 inch by 2-1/2 inch.

view full answer...

Answer 10

The Replacement Control Module for Lippert Ground Control 3.0 Leveling System #LC85ED is part of the Ground Control system that does have a wireless remote compatible with it like the part #LC358601. It is not a BlueTooth connection though.

view full answer...

Answer 11

Since the left side jack of your Lippert Ground Control 3.0 is not responding, and you have checked the fuses, since you mentioned switching the harnesses around and the issue then occurred on the other side I would say that is the issue over a…

view full answer...

Answer 12

You can upgrade the Lippert Ground Control 3.0 4-Point Set #LC358590 to the 6-Point Set #LC675817 later on but you will need to replace the control module to part #LC346005 as well as add the Left Rear Leg #LC342610 and Right Rear Leg #LC428493 and…

view full answer...

Correct Replacement for Grand Design Electric Jack Motor 160084

Product Page this Question was Asked From

Continue Researching