Recommended 24" x 30" x 3/8" Mud Flaps

Question

Question:

Do you have 24×30×3/8 reinforced mud flap?

asked by: Keith

0

Expert Reply:

It sounds like you're looking for the Buyers Products Truck Mud Flaps part # 337B30LXP which measures 24" wide x 30" tall x 3/8" thick. These are made of durable rubber which is very strong, have pre-drilled holes for an easy install, and are constructed right here in the USA.

expert reply by: Conner L

0

Answer 1

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 2

That spindle looks pretty well destroyed so best option is going to be to replace the axle. You are going to need to measure your current axles in a few places to get the correct one as we don't have access to what your numbers reference. You…

view full answer...

Answer 3

Generally speaking, the lube plate will need to cover the skid plate on the 5th wheel hitch. There are some pin boxes out there that will recommend a specific lube plate but most of the times this classification will be from the 5th wheel hitch…

view full answer...

Answer 4

A goose neck hitch ball, or the center of a 5th wheel hitch head for that matter, will be located either right over the rear axle or an inch or so forward of it. You do not want a goose neck hitch ball to be located behind the rear axle since this…

view full answer...

Answer 5

We do have Flat Mounting Plates #337MFBH2375F and 90-Degree Mounting Plates #337MFBH2375A for the Buyers Mud Flaps #337B30LXP. We also have the Anti-Sail Brackets in Galvanized #337405BZ, Chrome #337B2436ASBC and Stainless Steel #337405SS. You will…

view full answer...

Answer 6

The Dexter 12K oil bath axles can be changed over to grease without any issues. The oil does keep the bearings lubricated well, but there is a much higher risk of leaking which leads to a much higher risk of failure. I'd personally move to grease…

view full answer...

Answer 7

To change the 4.80x12 tires on your Karavan 5' x 8' utility trailer to ST175/80D13 tires you will need need to have 5-6" clearance between the top of the tire to the bottom of the fender, and 2-3" between the inside of the tire to…

view full answer...

Answer 8

The lights will need to be replaced, we have some great options for this. The Optronics LED Combination Trailer Tail Lights part #TLL160RK looks to be a great match for your existing taillights and the Custer Trailer LED Clearance Identification…

view full answer...

Answer 9

Of course! We have two really good options for you which both come if white or black. The first is the Advent Air RV Air Conditioner w/ Air Distribution Box, Start Capacitor, and Heat Strip - 13,500 Btu part #ACM135CH for white or part #ACM135BCH for…

view full answer...

Answer 10

On a 7 pin round which is the common connection on a semi trailer, the clearance/marker lights are at the 10 o clock position when you look at the trailer wiring connection. When looking at the connector on the back of the truck, that will put the…

view full answer...

Recommended 24" x 30" x 3/8" Mud Flaps

Product Page this Question was Asked From

Continue Researching