Can Roadmaster Base Plate Kit be Used as Recovery Point

Question

Question:

What is the maximum pull rating on the receivers? Can they be used as a recovery point as well as a tow point?

asked by: Rick

0

Expert Reply:

Base plate kits like the Roadmaster part # RM97RR that you referenced are not rated for use as a recovery point but within reason you'd be safe to use like this. They essentially are rated for pulling the weight of the vehicle so as long as the vehicle isn't extremely stuck you'd be okay.

expert reply by: Jameson C

0

Answer 1

To flat tow your 2021 Chevy Colorado it'll need to be the 4WD model and you'll need to follow the steps listed under "Recreational Vehicle Towing" in your owner's manual to get your vehicle ready to tow. If…

view full answer...

Answer 2

Since your RV has a Demco Air Force One kit installed already you'd need the second vehicle kit part #SM99209 for all of the components needed to install it on your 2021 Chevy Colorado.

view full answer...

Answer 3

To answer your first question, the tow hooks are removed when installing base plates and cannot be re-installed because the mounting holes for the tow hooks are used for the base plates. You could remove the base plates and then re-install the tow…

view full answer...

Answer 4

The Roadmaster Direct-Connect Base Plate Kit, #RM97RR is the Roadmaster part number of 524470-5. From conversation with our contact at Roadmaster, the (524470-5) will fit all models of the Ford Maverick with 2.5 hybrid motor, no interference with…

view full answer...

Answer 5

You are correct that the pair of tow hooks on your 2015 Jeep Cherokee Trailhawk would need to be removed in order to install base plates such as the the Roadmaster EZ4 #RM-521446-4 and unfortunately there is no kit available that would allow you to…

view full answer...

Answer 6

The instructions for the Demco Tabless Base Plate Kit #DM77YV are being added to page but I'll also send them to you separately. In the instructions they only show that the air dam needs a chunk cut out and that the shutters would remain. The…

view full answer...

Answer 7

Hey Carl, thanks for writing in, and that's a good question. Thankfully, the answer is no, you do not need to cut or trim the fascia/face plate on a 2024 Ford Maverick to install the Demco base plate that fits, which is the following part number:…

view full answer...

Answer 8

You have a good eye Richard, as there is not a difference between the etrailer and Demco base plates that fit your 2024 Ford Maverick: - etrailer Invisible Base Plate Kit e64FV - Demco Tabless Base Plate Kit #DM77YV Both will fit your '24…

view full answer...

Answer 9

Although it's not said, to install the Demco Tabless Base Plate Kit #DM77YV there may be some trimming of spoiler, air dam, grille or plastic fascia required depending on the model of this vehicle. To complete your flat towing setup, you're…

view full answer...

Answer 10

I recommend using the Roadmaster wiring for your 2024 Ford Maverick because I've found it to be the most reliable on the market. The correct kit depends on if your Maverick has LED lights or not: - LED Lights #RM38FR - Non-LED Lights #RM-15267…

view full answer...

Answer 11

Yes, you will have to drill holes in your lower fascia to attach the plug mount that is included with the Demco Tabless Base Plate Kit #DM77YV. This is a main reason I prefer to use the Roadmaster Direct-Connect Base Plate #RM97RR as they include…

view full answer...

Answer 12

Yes, the parts I recommended in the Q&A you're referencing would still be a great choice for your 2023 Ford Maverick. I've relisted those options below with one other side note on the braking system incase you have a diesel pusher…

view full answer...

Can Roadmaster Base Plate Kit be Used as Recovery Point

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching