Manual Roof Vent for Toy Hauler Trailer with 14-1/4 inch Square Opening

Question

Question:

Looking for Roof Vents for my toy hauler. What model would I need for an opening of 14 1/4 X 14 1/4 x 4inch Deep. Only need the hand cranked type but need the kit with inside and outside piece.

asked by: Jeff T

0

Expert Reply:

The 14-1/4 inch by 14-1/4 inch square RV roof vent opening is a standard size so basically any of the options we carry are going to work well. Since you said you just needed a manual crank the Ventline E-Z Lift Ventadome Trailer Roof Vent # V3092-603-00 would fit and work great. It would easily work with your 4 inch roof thickness as well but you'll need the garnish # VA0445-35 as well which is the portion of the vent that attaches to the inside of the roof and is correct height for a 4 inch thick roof.

expert reply by: Jameson C

0

Answer 1

The Alpha Systems Superflex TPO RV Roof Membrane #AL42CV has a thickness of 30 mil or .03".

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better…

view full answer...

Answer 4

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 5

The Carrier Air V RV Air Conditioner is no longer produced so a direct replacement of the same unit is not an option. However, we do have available the two Advent AC models that are designed as replacement units for the Carrier Air V. I recommend…

view full answer...

Answer 6

The Dometic Ultra Breeze Trailer Roof Vent Cover part #DMC38FR installs using brackets which secure to the vent lid flange. The brackets are screwed into the roof but the cover is attached to the bracket using pins and is easily removeable. I have…

view full answer...

Answer 7

The two most likely causes of a MaxxAir vent fan lid not opening or closing are either going to be a lift motor or operator failure. I recommend removing the motor and applying power directly to this to see if the shaft turns. If not, you know the…

view full answer...

Answer 8

Most slides have EPDM rubber roofs but because EPDM is rubber it requires treatment each year to keep it soft and prevent shrinkage. You could replace it with TPO which is another synthetic rubber that will last longer than the EPDM. The smallest…

view full answer...

Answer 9

The Alpha Systems Superflex TPO RV Roof Membrane #AL32CV is 30 mils thick. You will need the Alpha Systems RV Roof Replacement Installation Kit #AL74UV to install and seal the membrane on your roof.

view full answer...

Answer 10

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a great…

view full answer...

Answer 11

The Alpha Systems Superflex TPO RV Roof Membrane #AL25CV is 0.30" thick. This is the only thickness they offer currently for the TPO. You will need the Alpha Systems RV Roof Replacement Installation Kit #AL63FJ to install this roof membrane.

view full answer...

Answer 12

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...