How Is The Thule WingBar Evo Supposed To Be Spaced For Installation On A 2006 Nissan Altima?

Question

Question:

What do the underside markings of a 50inch evo squarebar go to? I have a 2006 Nissan altima that needs to be placed at the 34 mark.

asked by: Dean Z

0

Expert Reply:

I spoke to Thule, and they mentioned that the fit kit for the Thule SquareBar Evo Crossbars # TH712300 will need to be installed 38-3/4" apart for the front, and 37-7/8" apart for the rear.

Additionally, the crossbar for the front iwll need to be 10" from the top of the windshield and will need to be spaced 28" from each other.

I have attached a couple of images taken from the instructions manual for you to check out as well.

expert reply by: Bryce D

0

Spacing 1
(click to enlarge)

Spacing 2
(click to enlarge)

Answer 1

The 853-5113 part number that you referenced is the FootBase for the TK2 Tracker system. If you just need the FootBase then that would be part #753-2149. I confirmed this with my contact at Thule. If you are needing to replace the Tracker foot (part…

view full answer...

Answer 2

Replacement Foot Base #753-2149 does fit the Tracker II foot but it is also only compatible with certain Thule fit kits: TK1 (THTK1), TK6 (THTK6), TK7 (THTK7), TK8 (THTK8), TK9 (THTK9), TK10 (THTK10), TK11 (THTK11), and TK12 (THTK12).

view full answer...

Answer 3

The Replacement FootBase for Thule Tracker #753-2149 is what you currently have on the Thule tracks on your Leer shell. This footbase is for the now discontinued Thule Tracker square bar setup. You may be able to piece this system together even…

view full answer...

Answer 4

To remove or install the Railing Foot #753-2157-02 from the cross bar you need to push in the gray latch and slide down the black cover identified by the red arrow in the picture attached. This will allow you access to the allen head bolt to loosen…

view full answer...

Answer 5

It looks like you need the Replacement FootBase #753-2149 for the Thule Tracker roof rack. The hardware you need includes the following: Track Nut #853-2106 M6 x 17 mm Bolt #924-0617-15 M6 Washer #951061254 You'll want to reuse your Spacer…

view full answer...

Answer 6

Yes, the Replacement Railing Foot for Thule Rapid Tracker Foot Pack #753-2157-02 is the replacement for your Thule Tracker TH430R tower. The Universal Change Key #853-1251 is needed if you need to move a Thule One Key lock cylinder if you have that…

view full answer...

Answer 7

Looks like you are looking for the Replacement Railing Foot for Thule Rapid Tracker Foot Pack part #753-2157-02.

view full answer...

Answer 8

We do have the Replacement FootBase Thule Tracker RoofRack FitKits TK1 #753-2149. Let me know if you need anything else.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

How Is The Thule WingBar Evo Supposed To Be Spaced For Installation On A 2006 Nissan Altima?

Product Page this Question was Asked From

Continue Researching