Solution for Trailer That Sits Nose High When Towed with Taller New Truck
Question:
We just bought a new 2022 F250 with 4WD and it is much higher than our old 2005 one. With the coupler on our LQ horse trailer dropped all the way down the trailer is not level and there is not enough clearance of the truck bed. What are our best options? We do NOT want to convert our truck to a flat bed and we cant afford to buy a different trailer.
asked by: Connie W
Expert Reply:
Easiest solution will be to lift the suspension of the trailer so that it can sit level when hitched up to your new truck that sits up taller. For that you could use the Correct Track Tandem Lift Kit part # RR23QX which would give you a lift of up to 2-1/4 inches.
Products Referenced in This Question
Correct Track Trailer Alignment and Lift Kit - Tandem Axle
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- Tandem Axle
- RV Ride Control
more information >
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: Trailer Tire Sizing
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Recommended Suspension Enhancements for a 2022 Grand Design Imagine 2910BH
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Article: Slipper Spring Trailer Suspension System Review
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Is it Possible to Raise Suspension of Trailer that Has Slipper Springs
- Q&A: Installation of Dexter Kit # K71-385-00
- Q&A: Do Spring Seats Have to Be Welded to Install Axle Over Under Kit
- Q&A: Replacement Leaf Springs and Wet Bolt Kit For a 2007 Fleetwood Redline 33 Toyhauler