Troubleshooting Clearance Lights that Blink with the Turn Signals
Question:
When turn signals are turned on side markers lights blink. Can you help?
asked by: Ed K
0
Expert Reply:
It sounds like your clearance lights are run to the stop/turn signal circuit instead of being run to the running light circuit.
I would recommend you verify the wiring of your trailer and make sure that you have the correct circuit run to your clearance lights. The running light circuit is typically a brown wire and the circuit right next to the ground circuit that is jacketed on the 4-way.
Check out the FAQ article I attached on trailer wiring also.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed For Flat Towing a 2024 Ford Maverick Behind a 2010 Winnebago Journey With Air Brakes
- Q&A: Caliper Bolts for AL-KO/Hayes Disc Brake Caliper BP18-050
- Q&A: Replacement Oil Seal for AL-KO 568303
- Q&A: Does The Progressive Dynamics PD4655V Have A Lithium Jumper
- Q&A: Which Instructions Are Used Installing a Roadmaster Brake-Lite Relay in a Ford F-150 w/ Neutral Tow
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Diode for Charging Line From Motorhome to Towed Vehicle (Toad)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Article: Trailer Tire Sizing
- Article: Flat Towing Package for 2014-2015 Chevrolet Equinox