Winch Mounting Plate For A Front Mount Draw-Tite Hitch

Question

Question:

On your Draw-Tite 6495 winch mount it references the carry handles #6980. But I cant find the link to this part. Please advise.

asked by: Steve

0

Expert Reply:

The Front Mount Trailer Hitch Receiver Winch Mounting Plate (6495) has a universal design and the handles (6980) are no longer being produced.

The Bulldog Winch Hitch Mounted Winch Mounting Plate with Handles # BDW20011 will fit your front mount hitch. It is used for truck winches up to 12.5K, and has a stand 10 inch X 4.5 inch bolt pattern.

I attached a review video link below.

expert reply by: Noah E

0

Answer 1

Your 2024 Chevrolet Silverado 3500 will come with a 2-1/2" trailer hitch receiver. If your truck did not come with a reducer for a 2" receiver we do have the B&W #BWRHXA2182 if you need to use your 2" ball mount or hitch mounted…

view full answer...

Answer 2

You can use that upper hole on your hanger to install the #MR33WR. Make sure you don't tighten it down too much or you will pinch the leaf spring and it won't function properly. You will also need to make sure you have enough room to install…

view full answer...

Answer 3

Quite accurate; the margin of error is 3 percent for the etrailer Tongue Weight Scale for Campers and Utility Trailers - 2,000-lb Capacity #e99044. I don't see varying levels of liquid in the photos, but do see a customer photo with the scale…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

Hey Sam, so from previous customers we have found that your Airstream Flying Cloud 30FBQ has the Dexter Torflex #11 axles so for a lift kit you'd want the part #K71-724-02 which will give you a lift of 2-7/8 inches.

view full answer...

Answer 6

The Timbren kit #TFR250SDJ does not require a mounting plate above the axle as it is designed to contact the round the plate that is currently on the axle that is mounted below the spring pack. I would recommend sticking with this kit even though you…

view full answer...

Answer 7

You need to adjust the tension on your B&W Companion, #BWRVK3715. This done by adjusting the castle nuts, please view the attached installation video.

view full answer...

Answer 8

The MORryde X-Factor Crossmember part #MR33WR is designed for standard suspension so that is the one you will need to use. If your leaf spring hanger brackets are wider than 3" then you will need to drill per the instructions which I have…

view full answer...

Winch Mounting Plate For A Front Mount Draw-Tite Hitch

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching