Mounting Hole Spacing Of The Quest Marine Speakers # 292-100161
Question:
What is the Center on Center hole spacing? Is there a seal on the back? Are grills available for thi Planning on mounting this upside down under a camper on enclosures.
asked by: Robert W
Expert Reply:
The mounting holes for the Quest Marine Speaker # 292-100161 are 6-3/8" from center to center. There is not a seal of the back of the unit so I recommend using some butyl tape # AL28KV on the back to prevent water from leaking through.
We do not currently have grills available for this speaker but do offer a wide variety of speakers that come with grills if you could provide me with the size of the cutout hole you're placing the speaker in.
Products Referenced in This Question
Alpha Systems 1010 Non-Sag Sealant for RVs - White - 10.3 oz - Qty 1
- RV Roof Repair
- Sealant
- 10.3 oz
- Non-Sag
- White
- Alpha Systems
more information >
Product Page this Question was Asked From
Quest Marine Speaker - Recessed Mount - 6-3/4" Diameter - 50 Watts - Black - Qty 1
- Marine Speakers
- Single Speaker
- Recessed Mount
- 50 Watts
- 6-3/4 Inch Diameter
- Black
- Patrick Industries
more information >
Continue Researching
- Q&A: How Does Removable Grille for Jensen 6" RV Speaker # GR600B Fit
- Q&A: Does Power Converter Also Serve as Inverter
- Q&A: Will The Progressive Dynamics Control Center Work The 12 Volt Accessories Without Shore Power
- Q&A: Wiring Diagram for Progressive Dynamics Converter # PD4135K
- Q&A: How Much Do the Brophy Steel 3-Step Camper Scissor Steps SS03 Weigh
- Q&A: Height Range for the Brophy Three Step AS23
- Q&A: Picture of the TorkLift Scissor Steps Stowed
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Wiring Diagrams
- Article: RV Cell Boosters, How Do They Work?