Recommended Way to Transport Kayaks and an ATV On a 2015 Ram 2500 With RamBox Bed

Question

Question:

Hi I see this will work for a Dodge truck without ram boxes, looking for the same thing as I want to take my kayaks and ATV in the back of my truck but I have a short bed with Ram boxes. I have a 2015 Dodge Ram 2500 Diesel with Ram Boxes.

asked by: Tawnya O

0

Expert Reply:

I have a recommendation for you as the only ladder racks we have for your 2015 Ram 2500 with the RamBox bed are only 11" from the top rail. The Rhino-Rack Reconn-Deck Truck Bed Rack # RR33SP will only sit 11" above your bed rails and have to attach to the Ram factory utility tracks.

I recommend the Yakima Hitch Mounted Load Bar # Y01149-1150 be used with the Thule SquareBar Evo Crossbars # TH712500. The crossbars will mount to the roof of your Ram with the Feet # TH710501 and Fit Kit # TH145106. For the Goalpost I recommend the EcoHitch Hidden Front Mount Trailer Hitch Receiver # 306-X7900 on the front of your Ram, this will allow you to have your tailgate down for your quad and still be able to trailer tow. Both the roof rack and load bar are rated for up to 165lbs each allowing you to carry multiple kayaks above your truck.

The Malone Deluxe Kayak Carrier with Tie-Downs # MPG152 will give you foam blocks for your kayak to rest on and straps to secure it in place.

expert reply by: Bud M

0

Answer 1

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 2

I do have an option for you, but we do not carry the Dexter 072-027-00 you mentioned. However we do have the etrailer Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long #e64SR which will be 3/8" shorter but that is still close…

view full answer...

Answer 3

My contact at Yates Rubber advises that a nominal 8-inch keel roller does not measure exactly 8 inches; typically they are slightly smaller than the specified size, much the way a piece of 2 x 4 lumber is not exactly 2-inches by 4-inches. I took…

view full answer...

Answer 4

I looked up pictures of the taillights that are on the 3110 Featherlite trailers and for the LED version of them you would want the part #STL36RB and #STL37RB. It looks like the spare tire mounts for your trailer are something you would have to get…

view full answer...

Answer 5

According to my contact at Fantastic Vent the correct replacement lift motor to use in your vent is part #FVK6010-81, not item FVK-6050-80. The replacement motor does operate at a higher 17-RPM speed. Since your fan is of a lower rpm and manufactured…

view full answer...

Answer 6

Thanks for reaching out, Joe! I recommend using the Rhino-Rack Aero Bar Roof Rack for Camper Shells #Y02-480B which comes with 63" long tracks as well as 54" long crossbars which should give you a little bit of overhang on your canopy. Per…

view full answer...

Answer 7

Yes, you can use the NOCO GEN On-Board Battery Charger #NOC34FR on your pickup's parallel batteries without disconnecting them. If your batteries were in a series, they would have to be disconnected. Since your batteries are parallel and maintain…

view full answer...

Answer 8

The #99 trailer spindle is typically found on 9,000 lb and 10,000 lb axles. This is not a spindle that we carry at this time, but I did find some of the measurements. I have attached a diagram showing the dimensions of a #99 spindle for you to check…

view full answer...

Answer 9

Thanks for the picture of what you have and the info you listed. The correct wheel you need is the part #AM20794 that you referenced.

view full answer...

Answer 10

I have added a photo detailing the wiring connections for the Pollack Heavy-Duty, 7-Pole, Round Pin conncetor, #PK11700, see link. This is a SAE J560 compliant connector. The wiring diagram for the vehicle side connector, #PK11720, is pictured also.…

view full answer...

Answer 11

We do offer the Trailer Connector Adapter, #HM47425, which converts a 7-pole round connector to a 7-pole flat connector. This adapter works for tow vehicles with combined taillight wiring, meaning that the turn signals and brake lights run on the…

view full answer...

Answer 12

Truck Trolley test fit the part #TR87VR on the 2023 Ford F-150 and found that it does fit the 5-1/2 foot and 6-1/2 foot beds so it would for sure fit yours. We also had the chance to test fit it on a 2020 model and found that it fit and worked great.…

view full answer...

Recommended Way to Transport Kayaks and an ATV On a 2015 Ram 2500 With RamBox Bed

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching