Weight of 4-Step MORryde StepAbove RV Steps MR88RR

Question

Question:

The MoRryde Step Above steps are easily detachable according to the literature, but no where does it state how much the detached steps weight. I am considering a 4 step setup and I need to know if I can handle the steps when they are detached?

asked by: Lowell

0

Expert Reply:

The weight is 58 lbs for the 4-step MORryde StepAbove RV Steps for 23-3/4" to 26-1/4" Wide Doorways # MR88RR.

expert reply by: Kyle S

0

Answer 1

The standard clearance requirement for the MORryde StepAbove RV steps like part #MR88RR is 3/8 of an inch which is the same for the #MR28RR.

view full answer...

Answer 2

If you are measuring at the lip that the screen door rests on, you are likely shorting yourself a little bit. You want to measure from the inside of the door flange to inside of the door flange. I have included a couple pictures that show the…

view full answer...

Answer 3

The most sturdy type of steps would be the fold down type as these make contact with the ground so there will be little to no bounce. The MORryde StepAbove RV Steps part #MR88RR would fit a 24" wide doorway. It however has 8"…

view full answer...

Answer 4

Hey Jeff, from previous customers who have given us the part number you mentioned we have found that the matching MORryde StepAbove is the part #MR65RR which has 23.5 inch wide steps and is a 3-step setup with the strut assist.

view full answer...

Answer 5

This will depend on if you have disc or drum brakes on your triple axle boat trailer. Disc Brake Kit #HS381-9067 Drum Brake Kit #HS381-9066 Each kit contains the correct electric over hydraulic actuator, 7-way wiring and breakaway components. If…

view full answer...

Answer 6

Really you're going to need to measure the distance where the leveling system is going to be installed. If that distance is more than 20', then you're going to want the 6 point Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling…

view full answer...

Answer 7

I spoke with a MORryde tech and found that the 36" measurement would be pretty close to the end of the leg adjustment slots but that you would still have 2-4" of adjustability. The issue that you'll run into though is that the first…

view full answer...

Answer 8

It sounds like what you are lookin for is actually the replacement heavy duty shackle and bolt kit part #018-026-05 and the replacement shackle part #018-024-01. These are super thick at 1/2 inch and the correct length from bolt hole to bolt hole at…

view full answer...

Answer 9

The doorway width - the width from flange to flange of your doorway - needs to be between 23-3/4 inches and 26-1/4 inches, so yes, your 24 inch door will allow you to use the MORryde steps you asked about, which are the following part number: -…

view full answer...

Answer 10

I don't know what type of brackets were used on your 2022 Heartland RV Torque 5th Wheel but we carry the #LC349975, which can really only be installed at one height since they have lip that butts up against the bottom of the I-Beam. If clearance…

view full answer...

Answer 11

I'm not quite sure what you got going on but what I can tell you is that in order to install the MORryde Safe-T-Rail Telescoping RV Hand Rail #MR54BR you're looking at, you are going to need: -No trim or obstructions including around a…

view full answer...

Weight of 4-Step MORryde StepAbove RV Steps MR88RR

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching