Pole Tongue Adapter to Use with Equal-i-Zer Weight Distribution System

Question

Question:

Hi, I have a 1000 lb rated Equalizer system. Is this compatible with my system?

asked by: Mike S

0

Expert Reply:

Equal-i-zer actually makes a pole tongue adapter for use with their weight distribution systems with the part # EQ95-01-5950 which would be the correct adapter to use. I would not recommend using the Reese adapter as it was not designed for your WD and would not work.

expert reply by: Jameson C

0

Answer 1

The Blue Ox TrackPro Weight Distribution w/ Sway Control #BLU36FR you referenced would make a great addition on your 2012 Toyota Tundra. To determine your setup's total tongue weight you will need to measure the tongue weight of your Lance 2075…

view full answer...

Answer 2

I found a weight distribution hitch that will fit your 24.5-inch tongue. That system is the Blue Ox TrackPro Weight Distribution w/ Sway Control - 7-Hole Shank #BLU36FR. The TrackPro only requires 20" to 25" to mount the lift-brackets. The…

view full answer...

Answer 3

Yes, the Blue Ox TrackPro Weight Distribution w/ Sway Control - 7-Hole Shank - 8K GTW, 800 lbs TW item #BLU47FR can be used with the Pole-Tongue Adapter for Equal-i-zer Weight Distribution Systems - 14,000 lbs GTW, 1,400 lbs TW item #EQ95-01-5950. If…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. The Replacement Head for Blue Ox SwayPro Weight Distribution Systems part #BXW4011 is for…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

For your Dometic DuoTherm the Advent Air Unit part #ACDOM150 would be your best option that will give you the higher BTU rating 15k and easily connects to the current wiring you have now.

view full answer...

Answer 11

The Electric Jack w/ Footplate and 7-Way Plug #EJ-3527-BBX uses a 7-way RV-style plug. I have included a diagram that shows the pin-out for RV style 7-way plugs. This will show you what each pin does. I have also listed the functions below and linked…

view full answer...

Answer 12

The round or trunnion bars refers to the end of the spring bars. Round bars are typically designed for lighter applications, are a bit harder to install and are usually priced lower than trunnion bars. Trunnion bars are typically designed to be used…

view full answer...

Pole Tongue Adapter to Use with Equal-i-Zer Weight Distribution System

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching