What Is The Overall Size Of The Atwood Propane Gas Detector?

Question

Question:

what is the overall size including the bezel of the Atwood AT36681? I have an old Protector series, flush mount. My opening size is 3 1/4 wide x 4 high.

asked by: Roger

0

Expert Reply:

The overall size of the Atwood RV Carbon Monoxide and Propane Gas Detector # AT36681 is 33-9/16" long x 3-7/16" wide x 1" deep, and includes a white adapter plate for a flush mount installation.

expert reply by: Bryce D

0

Answer 1

The Atwood 31013 is no longer made. The best choice for replacement is the RVCO #RS34FR which mounts flush against the wall, and the overall measurements are 4-1/4" square, and it sticks out 1/2" from the wall. Works with 2-wire…

view full answer...

Answer 2

Since the Atwood LP DOB 31013 is no longer available, your best option is to do a full replacement. I recommend going with the: -RV Propane Gas and Carbon Monoxide Detector #RS34FR for white, or the: -RV Propane Gas and Carbon Monoxide Detector…

view full answer...

Answer 3

The Atwood 2001 Protechtor you have is for detecting just propane whereas the part #AT36681 detects propane and carbon monoxide.

view full answer...

Answer 4

I spoke with a contact at Atwood. The main concern for the GS961LP is ensuring that it receives 12V power. Because the Atwood LP Gas Detector RV 12V White 36719 has this, it's highly possible that it can work for you. However, we do not sell…

view full answer...

Answer 5

I wasn't able to find the Atwood 36720 RV Propane Gas Detector you mention, however I was still able to find the RV Propane Gas Detector #RS64FR in white, or #RS44FR in black to work as a replacement for your Protechtor Series 2001 LP Gas…

view full answer...

Answer 6

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 7

Based on the picture you provided the Atwood RV Propane Gas Detector - 12 Volt - White #AT36720 would be an exact replacement for your current Atwood RV Propane Gas Detector.

view full answer...

Answer 8

We have exactly what you are looking for. You will want the Atwood combination gas and carbon monoxide detector #AT36681.

view full answer...

Answer 9

Two power supplies are needed for the Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 because if one were to fail it allows the other to act as a backup in case of a gas leak during the power outage.

view full answer...

Answer 10

We've seen this issue before on your Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 and the beeping every 40 seconds indicates "a fault has been detected that compromises some detector function." What you need to do is use…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

What Is The Overall Size Of The Atwood Propane Gas Detector?

Continue Researching