What Are The Dimensions Of The Replacement Mounting Hardware For Go Power Rigid Solar Panels?

Question

Question:

What are the dimensions of this mounting bracket? Or more specifically, how high off the roof would the solar panel be?

asked by: Bryan W

0

Expert Reply:

I went out to our warehouse and measured the Replacement Mounting Hardware for Go Power Rigid Solar Panels # 34272708 like you're requesting, and measured:

-1-3/8" for the length side to side of the bracket.

-1-1/8" for the height,

-2" for width, and the screw holes measure 1" on center with a diameter of 3/16".

So affectively the solar panel would be mounted 1-1/8" above your trailer.

I have attached a product overview video as well as a diagram depicting these measurements.

expert reply by: Bryce D

0

Solar Bracket Measurements 1
(click to enlarge)

Solar Bracket Measurements 2
(click to enlarge)

Answer 1

If your Jensen RV Stereo #JWM40 (JWM41) is not turning on or you are not getting front panel operation there are a few things you can try. - Try the reset button - Check fuse - Check 12V+ on accessory wire to radio (RED wire) - Check Ground Since it…

view full answer...

Answer 2

The Jensen RV Stereo #JWM40 is the same thing as the JWM41, just different item codes on our end. Most likely you will use every wire from the wiring harness, but for any wires that you don't use you can either leave them alone or use some…

view full answer...

Answer 3

The Jensen RV Stereo w/ DVD Player #JWM40 requires a 7-1/16" wide by 3-3/8" tall cutout hole. If your current cutout won't fully be covered by this stereo you can cut a piece of wood or plastic to cover the old hole and cutout the new…

view full answer...

Answer 4

To hook up a second battery to your Go Power Overlander Solar Charging System with Digital Solar Controller - 200 Watt Solar Panel Item #34282181 you'll need the following: Some 10 AWG wire to run a positive and negative line from the second…

view full answer...

Answer 5

You can certainly add a sprayer to your Dometic 310 part timer toilet after the fact. You'll need part #DOM75FR which includes the vacuum breaker, the sprayer and hose and all the necessary hardware. You can see a product video for this item by…

view full answer...

Answer 6

To replace your JVR9000 I recommend the Jensen RV Stereo - Double DIN - AUX/USB, Bluetooth #JWM40. It has slightly different dimensions that can be easily fixed using a dash plate. This won't have a monitor to watch your video feeds from so…

view full answer...

Answer 7

The words solar ready unfortunately mean different things in the RV world. It could mean that you have everything needed but the panels or it could mean that you just have an access plate on your RV's roof or something in between those. I have…

view full answer...

Answer 8

We have exactly what you're looking for with bearing kit #BK3-300. This includes one inner bearing and race, one outer bearing and race, the correct grease seal and a cotter pin for your Dexter 5,200 lb axle. For cross reference I'll list the…

view full answer...

Answer 9

The laws can be a little fuzzy and vary from state to state but it seems like if the trailer couples to a ball then you have to have safety chains. Technically, by using Bulldog adapter #BD0289640300 the gooseneck trailer is no longer coupling to a…

view full answer...

Answer 10

We've actually had this one asked before and have consulted with MaxxAir. Even though you can technically install the MaxxFan Deluxe Roof Vent #MA00-06401K wired to a separate switch, it is not recommended. The reason for this is that their fans…

view full answer...

Answer 11

For your 2002 Winnebago Adventurer, from what I can find online it looks like your lugs are 1-1/16 inch. For this I recommend the Wheel Masters Lug Nut Covers - Stainless Steel - Ford - 1-1/16" - Qty 8 #WM8011 that you referenced. I am not sure…

view full answer...

Answer 12

Actually the 12 volt Solera awnings are the ones that have the ability to add the wind sensor part #LC715123 and the rain dump sensor #LC715124. You can convert to the 18 volt system if you wanted to with the #LC759404 that you referenced but those…

view full answer...

What Are The Dimensions Of The Replacement Mounting Hardware For Go Power Rigid Solar Panels?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching