What is the Angle of Hook for the Gen-Y Hitch Aluminum Loading Ramp Set
Question:
We are interested in ramps # GY52YR Is the hook at the top end at 90 degrees to the surface?
asked by: Danny K
0
Expert Reply:
The hooked end on the Gen-Y Hitch Aluminum Loading Ramp Set # GY52YR is a 90 degree bend to the top part of the ramp that you drive on (see attached photo).
expert reply by:
Jon G
0
Product Page this Question was Asked From
Gen-Y Hitch Aluminum Loading Ramp Set - 10' Long x 15" Wide - 14,000 lbs
- Car Ramps
- Loading Ramps
- Open Trailer
- 15 Inch Wide
- 120 Inch Long
- Car Hauler Ramps
- 14000 lbs
- Gen-Y Hitch
more information >
Continue Researching
- Shop: Gen-Y Hitch Aluminum Loading Ramp Set - 10' Long x 15" Wide - 14,000 lbs
- Q&A: Wheel and Tire Recommendation For Jet Ski Trailer with Tire Size ST175/80R13
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Q&A: Can You Replace A GE Air Conditioner Be Replaced With An Advent A/C?
- Q&A: How to Determine the Correct Replacement Bearings for a Trailer
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Solution for Atwood Surge Brake Coupler Needing Replacement Parts
- Article: Big Truck Big RV
- Q&A: Recommended Trailer for Two Titan Propel 12 Kayaks
- Article: How to Use a Roof Rack (Like a Boss)
- Article: Car Camping Checklist
- Article: Pintle-Hitches
- Article: Best Ladder Racks
- Article: Flat Towing Package for 2008-2011 Honda CR-V
- Article: Trailer Wiring Diagrams