Are There Recommended Safety Chain Extensions for Camper Trailer

Question

Question:

I’m looking to lengthen my safety chains on my rPod camper. It seems a link or two short. Any suggestions?

asked by: David P

0

Expert Reply:

I do have an option for you but we don't really offer safety chain extensions as it's usually best to just replace the chains entirely with a longer set so you don't run into issues with capacity. The Safety Chain with 1/4" S-Hook part # TCTSCG30-772-03x2 is our longest option at 36" per side with a 5,000 lb weight capacity.

I have attached our full list of options below if the weight/length of the above won't work.

expert reply by: Conner L

0

Answer 1

Safety chains on trailers should be crossed under the trailer tongue. The idea is that if the coupler pops off of the ball the safety chains will catch it so it doesn't drag on the ground. We have numerous safety chain parts available and I have…

view full answer...

Answer 2

You can try using quick-links to add length to your safety chains, but your best option is going to be to use a different set of chains that are longer. For a 27 inch long chain rated at 5K, go with the #2118-605-04. For a 48 inch chain with the same…

view full answer...

Answer 3

It really depends on your setup, if the safety chain loops on your tow vehicle are spaced far apart then you will need more slack to make a tight turn then if they were closer together. What I would recommend you do is connect your trailer to your…

view full answer...

Answer 4

If you want to just add on some sort of extension you can use Safety Chain Quick Link #C82932 which has a working load limit of 3300-lbs. This will give you about 3-inches additional length. Ideally trailer safety chains will be one continuous chain,…

view full answer...

Answer 5

I definitely understand how safety chain capacities and determining exactly what chain rating you need for your trailer can be a bit confusing. To keep it as simple as possible, safety chain requirements state that the breaking strength of EACH…

view full answer...

Answer 6

For a winch like the Superwinch S6000 Winch #CU854754 you will simply want to use the Trailer and Vehicle Electric Winch Wiring Kit #BDW20207. Since winches can vary on how much they can pull this also affects how much power they need. For a winch…

view full answer...

Answer 7

The internal depth of the Replacement Center Cap for Taskmaster Viking Aluminum Trailer Wheels #CXF106C is approximately 2-1/4".

view full answer...

Answer 8

The etrailer #CA-5400-B weld-on coupler you were looking at would be a great replacement for your current Parker Performance A-frame coupler. This coupler has a 2-5/16 inch ball and a weight capacity of 14,000lbs. I have linked this product to this…

view full answer...

Answer 9

The jack already has a mounting bracket welded to it, as shown in the provided photo. If your trailer does't have a mounting plate, the easiest way to provide a plate would be to replace your coupler with something like #PSE338050303 for a 2 inch…

view full answer...

Answer 10

There is a 4 inch diameter hole that needs to be cut in the skid shield of your 2016 Toyota Tundra to be able to install the Draw Tite front hitch part #65080 that you referenced. I attached a diagram that shows where it will be.

view full answer...

Answer 11

I first recommend taking a quick measurement on your trailer to ensure that the Trailer Wheel Center Cap #319EZ will fit over your existing Bearing Buddies. The inner depth of the center cap is 3-1/8 inches to the tabs on the removable plug on the…

view full answer...

Are There Recommended Safety Chain Extensions for Camper Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching