Trailer Brakes Have Stopped Working
Question:
Replaced my break box, There is power at the box, when engaged there is no read out at break box. Also tried the manual slide. And put the gain up to 9 with no results. The trailer lights and brake lights work. Is this a possible fuse issue or bad ground? They all of a sudden stopped working. Any tip would be appreciated. Thanks
asked by: Donald F
Expert Reply:
There's a number of possible issues to take a look at with trailer brakes not working. You will need to find out if the issue is on the brake controller, tow vehicle, or trailer. To test the brake controller, sever the blue wire a couple inches from the back of your controller. Then use circuit tester # PTW2979 to test the end of the blue wire coming out of the controller. It should only have power when you apply the manual override; if it shows power at idle then there is an issue with the controller and it will need to be replaced.
If the controller tests fine, reconnect the blue wire and move on to the truck side trailer connector. Often, corrosion or dirt may be the cause of a short in a trailer connector. Check the plug to see if there is any type of corrosion built up that may be hampering its functionality.
You will also want to test the brake output pin on the 7-way socket; it should only show power with the manual override. If it shows power any other time then there is a short somewhere between the connector and the brake controller you will need to find.
If the truck side checks out then it could be the wiring to the brake magnets or possibly the magnets themselves. Inspect the power wires to the magnets and look for wires that may be pinched or otherwise damaged and fix as necessary. You'll also need to make sure the ground wires are attached to bare metal surfaces and free of any paint, dirt or corrosion.
You'll want to visually inspect the magnets; if you can see the copper windings coming through the magnets will need to be replaced. To test the magnets use Multimeter # PT89ZR and follow the help article I have linked below to guide you.
Products Referenced in This Question
Product Page this Question was Asked From
Digital Multimeter with 42" Long Test Leads - LED Display
- Electrical Tools
- Testers
- Multimeter
- Yellow
- Performance Tool
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: Electric Trailer Brakes not Working
- Q&A: Does The Progressive Dynamics PD4655V Have A Lithium Jumper
- Article: Trailer Wiring Diagrams
- Q&A: Should Electric Trailer Brakes Have Continuity Between The Two Wires?
- Q&A: How to Wire a Trailer with Electric Brakes
- Q&A: Can An A-Frame Trailer Jack Be Wired To The 7-Pole Cable
- Q&A: Difference Between Dexter Axle Grease Seals 010-036-00 and 010-054-00
- Q&A: Replacement Leg For Gen 2 MORryde StepAbove RV Steps
- Article: Troubleshooting Brake Controller Installations
- Article: Testing Brake Controls
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: Brake Controller Installation: Starting from Scratch