Comparing Prest-O-Fit 4-Piece Step Rug Set for 2nd Gen MORryde StepAbove RV Steps PR69QR and PR23SR

Question

Question:

Are these the same part? If not, what is the difference. Prest-O-Fit 4-Piece Step Rug Set for 2nd Gen MORryde StepAbove RV Steps - 23-1/2inch Wide - Brown - PR23SR Prest-O-Fit 4-Piece Step Rug Set for 2nd Gen MORryde StepAbove RV Steps - 23-1/2inch Wide - Brown - PR69QR Thanks.

asked by: Greg K

1

Helpful Expert Reply:

The Prest-O-Fit 4-Piece Step Rug Set for 2nd Gen MORryde StepAbove RV Steps part # PR69QR and part # PR23SR are the exact same.

expert reply by: Conner L

1

Answer 1

They really are very similar and interchangeable but the #MR84VR is for replacing a Lippert 1621 pin box whereas the part #MR94VR is for replacing a Trailair setup that also was for the 1621SHD.

view full answer...

Answer 2

In order to choose the correct Trailair Flex Air pin box like the #LC328492, or any other pin box for that matter, is by checking the spec sticker on the current pin box for a model number. We don't have a database that tells us what pin box is…

view full answer...

Answer 3

The Curt Flex Air 5th Wheel Pin Box - Lippert 1621, #LC328492, and other Curt Flex Air 5th Wheel Pin Boxes are designed to be direct replacements to your current pin box. The long jaw models, medium jaw descriptors you refer to simply identify the…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…

view full answer...

Answer 6

The most likely cause of the "no signal" error you are receiving with the Furrion Vision S Wireless RV Backup Camera System part #FOS43TASF is due to an interruption on the camera's power wire. Make sure that the camera is receiving…

view full answer...

Answer 7

Demco actually has a kit that was designed to convert an Air Force One kit to a Stay in Play DUO which is what you would need since you have hydraulic brakes with the part #SM99231. This will work with what you have now and work great. If you send me…

view full answer...

Answer 8

You can have more than one iPhone "connected" to the Lippert Tire Linc system part #LC37VR but only one can be used at a time. So basically you or your wife could have their phone connected but if you needed to switch between the two phones…

view full answer...

Answer 9

Though the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F2709 will offer you more support when fully loaded, they will also affect your ride a lot more when not loaded. Even at the lowest setting (5 psi). I really only recommend…

view full answer...

Answer 10

Trailer weight distribution hitches (WDH) such as the Curt TruTrack systems #C17499 and #C17500 do come in varying weight capacities. Selection of the correct one for any given towing setup is based on the actual fully-loaded tongue weight (TW). It…

view full answer...

Answer 11

There is a wireless camera you can use for your travel trailer that will always be on. It is the Furrion Vision S Wireless RV Backup Camera System w/ Night Vision item #FOS05TASF. It comes with a 5" monitor and you will want to wire the camera…

view full answer...

Answer 12

Yes, the Voyager WiSight 2.0 Wireless RV Backup Camera #ASA84YR will have consistent signal with your setup. The camera and monitor both have a wireless range of 60 feet or more. So even with about 52' between them, you will be well within…

view full answer...

Comparing Prest-O-Fit 4-Piece Step Rug Set for 2nd Gen MORryde StepAbove RV Steps PR69QR and PR23SR

Products Referenced in This Question

Continue Researching