12V Power Consumption On A Trailer Connector Using A RV Style Trailer Socket
Question:
Is the 12 power blade on RV trailer connector Continuous battery or switched by ignition switch?
asked by: Rev. P
Helpful Expert Reply:
When using The Pollak Metal 7-Pole, RV-Style Trailer Socket - Vehicle End # PK12703 the socket is switch on by ignition switch. If the battery is not on then it will be getting no power.
The wiring configuration is below:
White - Ground - 10 gauge
Blue - Electric Brake - 12 gauge
Green - Tail, License and Running Lights - 14 gauge
Black - Battery Charge - 10 gauge
Red - Stop and Left-Hand Turn Signal - 14 gauge
Brown - Stop and Right-Hand Turn Signal - 14 gauge
Yellow - Auxiliary Circuit - 14 gauge
I attached a review video link below.
Product Page this Question was Asked From
Pollak Metal 7-Pole, RV-Style Trailer Socket - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Continue Researching
- Q&A: Recommended Replacement For A Dometic DOTR12CB RV Microwave
- Q&A: Do 8k Oil Bath End Caps On Lippert Axle Interchange With Dexter End Caps
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Wiring Harness Recommendation for 2017 Lexus RX 350 with Towing Package
- Q&A: LaSalle Bristol XTRM Roof Membrane Install Kit Recommendation
- Q&A: Recommended Electric Over Hydraulic Brake Set Up for 2016 Montana 3710FL 5th Wheel
- Q&A: Replacement Grease Seals For TRP GS-1719DL
- Q&A: Is Adapter Needed to Install Dometic Water Heater # DMC74FR In Place of Atwood
- Article: Brake Controller Installation: Starting from Scratch
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)